Advertisement
5.2.
OPERATING INSTRUCTIONS
5.2.1.
Disconnect the nibbling tool from the air line.
5.2.2.
If required, to improve access to the workpiece, the die can be rotated in 90° intervals through 360°.
5.2.3.
Ensure that the workpiece is marked out and secure.
5.2.4.
Connect the air line to the nibbler.
5.2.5.
Start the nibbler by depressing the trigger and introduce the nibbler die slot to the sheet metal to be shaped.
5.2.6.
Apply light pressure only to move the tool in the desired direction through the metal.
5.2.7.
The design shave depth is 0.6mm per stroke and the punch is Ø4.4mm, shearing efficiency can be affected using the adjustable throttle
valve situated in the moulded handle and shown in fig.3.
5.2.8.
Exhaust air can be directed away from the user by rotating the exhaust baffle shown in fig.3.
6. MAINTENANCE
.
WARNING! Disconnect the nibbler from the air supply before changing the punch and die, servicing or performing maintenance.
‰
Replace or repair damaged parts using genuine parts only.
9
WARNING! Nonauthorised parts may be dangerous and will invalidate the warranty.
‰
6.1.
If the air system does not have an oiler, lubricate the air nibbler daily with a few drops of the air tool oil, dripped into the air inlet before
use. To order air tool oil use Sealey part Nos. ATO/500 or ATO1000.
6.2.
Loss of power or erratic action may be due to the following:
a).
Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To
remedy, check the air supply and follow instructions in section 4.
b).
Grit or gum deposits in the nibbler may also reduce performance. If your model has an air strainer (located in the area of the
air inlet), remove the strainer and clean it. Flush the nibbler out with gum solvent oil or an equal mixture of SAE No 10 oil and
kerosene. Allow to dry before use. If you continue to experience problems, contact your local Sealey service agent.
6.3.
For a full service contact your local Sealey service agent.
When not in use, disconnect from air supply, clean nibbler and store in a safe, dry, childproof location.
9
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 36 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SA649
Issue 2 (ALL)
REGISTER YOUR
PURCHASE HERE
18/05/23
Advertisement
