Simplicity 5200 Series Operator's Manual page 8

Mower installation & Removal
Figure 3. L.H. Belt Stop
A. Belt Stop D. Mi
B. Belt E. Tr
C. PTO Pulley F. Pii
D. Mower Hitch Arm
E. Tractor Hitch
F. Pins
Figure 4. Mower Hitch Attached
A. Tractor Hitch
B. Pins
C. Safety Clips
D. Drive Belt
Figure 5. Right-Hand Belt Stop - 42'
Mowers
A. Belt Stop
B. PTO Pulley
C. Belt
9. Install the clips (C, figure 4) in the pins.
10. Slip the mower drive belt onto the
engine PTO pulley loosening belt stops
as necessary. The left-hand belt stop is
shown in figure 3. The right-hand belt
stop for 42" mowers is shown in figure
5. Position belt stops 1/16" from belt.
11. Insert the rear end of the PTO rod in the
hole marked "MOW" in the PTO arm
(B, figure 6). Insert the spring clip (C).
12. If installing mower for the first time,
check the following adjustments.
a. Mower belt tension (page 27).
b. PTO pulley belt stops (page 27).
c. Mower belt stops (page 27).
d. Mower levelling (page 28).
e. Blade brake (page 30).
f. Lift lever (page 31).
6