Safety instructions
•
The device is only suitable for use in dry indoor ar
eas and may only be operated under supervision!
•
The device must not be put into operation if it
shows visible signs of damage.
•
The device may only be used for training purposes.
Commercial use is not permitted!
•
Make sure that only original spare parts are used
for necessary repairs!
Instruction sheet 739 952
Model HV Battery "Cells"
1
Cover for fault switch, lockable
Measuring point potential equalization battery
2
housing
DC charging voltage input
3
Changeover switch charging mode
4
5
Cell balancing cables 1-3
Slot for BMS
6
7
Service disconnector (option 1) and pilot line
HV battery fuse
8
Cell balancing lines 4 and 5
9
10
Pilot line connection
Battery housing connection
11
12
Communication lines to
Fault switch 1 - 5
13
Connection potential equalization battery
14
housing to battery minus (body ground)
Slot for battery cell module 1
15
16
Slot for temperature simulation of cell module 1
Cell module selection switch
17
Slot for temperature simulation of cell module 2
18
19
Slot for battery cell module 2
Connection HV+ and HV-
20
21
Connection body mass
•
The device is not protected against reverse polarity
of the cell modules and can thus be permanently
damaged incl. plug-in elements!
•
Storage only with removed plug-in elements!
•
For handling lithium cells, the corresponding safety
instructions and data sheets must be observed!
1 Description
The device described here is used to record battery cells and
BMS. In addition, various errors can be switched.
© by LD DIDACTIC GmbH · Leyboldstraße 1 · D-50354 Hürth · www.ld-didactic.com
Tel: +49-2233-604-0 · Fax: +49-2233-604-222 · Email: info@ld-didactic.de · Technical alterations reserved
739 958