Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for VONROC TC502AC
Summary of Contents for VONROC TC502AC
- Page 1 TILE CUTTER 450W TC502AC EN Original Instructions...
- Page 2 WWW.VONROC.COM...
-
Page 3: Safety Instructions
The term “power tool” in the warnings refers wear eye protection. Protective equipment to your mains-operated (corded) power tool or such as dust mask, non-skid safety shoes, hard battery-operated (cordless) power tool. hat, or hearing protection used for appropriate conditions will reduce personal injuries. WWW.VONROC.COM... - Page 4 Maintain power tools. Check for misalignment or • Use safety goggles. binding of moving parts, breakage of parts and • Use a dust mask. any other condition that may affect the power tool’s operation. If damaged, have the power tool WWW.VONROC.COM...
-
Page 5: Machine Information
TECHNICAL SPECIFICATIONS • Connect the riving knife with the two screws and the plate. Model no. TC502AC Mounting the saw blade (2) Voltage 230V~ / 50Hz • Remove the two screws from the lower blade... -
Page 6: Operation
Before starting the cutting job, always ensure there cutting blade. is sufficient water in the water tray. The diamond • Loosen the fence knobs (7) and set the required blade must run through the water. Keep a close eye distance. WWW.VONROC.COM... -
Page 7: Maintenance
WARRANTY switch off the machine and unplug the power cord. VONROC products are developed to the highest The machines have been designed to operate over quality standards and are guaranteed free of a long period of time with a minimum of mainte- defects in both materials and workmanship for the nance. - Page 8 In no event shall VONROC be liable for any incidental or consequential damages. The dealers remedies shall be limited to repair or replacement of nonconforming units or parts.
- Page 11 9 June on the restriction of the use of certain hazardous substances in electrical and electronic equipment is in conformity and accordance with the following standards and regulations: EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3, EN62841-1, EN12418 2006/42/EC, 2014/30/EU, 2011/65/EU, 2012/19/EU Zwolle, 01-04-2023 H.G.F Rosberg VONROC • Lingenstraat 6 • 8028 PM Zwolle • The Netherlands WWW.VONROC.COM...
- Page 12 ©2023 VONROC WWW.VONROC.COM 2304-26...