Advertisement
Quick Links
Advertisement
Related Manuals for Dantherm 087353
Summary of Contents for Dantherm 087353
- Page 1 Condensate pump Installation Manual Rev. 3.2 1 ...
- Page 2 Pump kit components Purpose If the condensate water cannot drain properly, a condensate pump Part number 087353 can be installed. This document describes how this is to be done. Tools needed You need the following tools to install the pump: Standard handtools including screwdrivers and pliers.
- Page 3 Pump kit components, continued In the kit The kit includes the following components: Part A Condensate pump B By-pass partition C Transparent pressure equalization hose D Cable tie E Y-branch F 2 and 4 pole connector (one of each) G Nut H Screw I Washer J Water pump bracket...
- Page 4 Pre-assembled condensate pump Introduction The illustration below shows the pre-assembled condensate pump. Illustration 4 ...
- Page 5 How to install the condensate pump onto the unit Introduction When the condensate pump has been prepared, it can now be mounted onto the unit. Procedure Procedure Follow these steps to fit the pump, power and signal wirings between the inlet and outlet pipes: Step Action...
- Page 6 How to connect the condensate pump if mode A Operation mode A: Mount the pump on the T4 side of the unit where the drain is located, and follow the picture steps below: Procedure Follow these steps to install the condensate pump in mode A: Step Action Place the transparent pressure equalization hose beneath this edge of the...
- Page 7 How to connect the condensate pump if mode B Operation mode B: Mount the pump on the T4 side of the unit where the drain is located, and follow the picture steps below: Procedure Follow these steps to install the condensate pump in mode B: Step Action Mount the pressure equalization hose to the reservoir.
- Page 8 How to connect the condensate pump to the control box Control box and Follow the instructions below to connect the control box: wirings Step Action Connect the 4 pole green connector to the control box. Connect the 2 pole green connector to the control box. Disconnect the white connector J2 in the lower left corner of the PCB.
- Page 9 Notes 9 ...
- Page 10 Notes 10 ...
- Page 11 Notes 11 ...
- Page 12 12 ...