Samsung HP-P5071 Owner's Instructions Manual page 12

PDPI to
1
Remove the screws from the back of the PDP.
Connect insulation holders to screws (see the illustration below}.
If you are uncertain about installation, hire a specialist to install the wail mount bracket.
Be sure to check that the insulation holders are completely secured on both the left
and right side after hanging the PDPon the wall mount bracket.
Be careful to avoid getting your fingers caught during installation.
Make sure the wall attachment panels are tightened. Otherwise the PDP may fail.
Tighten the screws of the insulation holders to the back of the PDR
4
Put the 4 insulation holders on the PDP
in the grooves of the wall mount
bracket and pull down on the PDP (@)
to secure it to the wall mount bracket
(@)_ Tighten the screws as shown (@}
so that the PDPcannot be separated
from wail mount bracket.
PDPpanel
o,
Wall attachment panel Wall
bracket
o@
o A 5 inch gap is needed between the back of the Plasma TV and the wall.
12