Viking SKADI III User Manual page 3

EN
VIKING SKADI III - User manual
Thank you for choosing a VIKING product.
When using, please refer to the technical specifica�ons of each model, which can be found in the
user manual or on the website www.best-power.cz
Method of use:
1. Please check that the device is fully charged before first use of the power bank. The capacity and
charging status are indicated by the LEDs near the ON/OFF bu�on.
2. The charging �me indicated is for informa�on only and may vary according to the power of the
charging source.
3. Specifica�ons, appearance and descrip�on are subject to change due to product improvements
and updates.
4. Always use a suitable charging cable.
5. Slight hea�ng of the product is normal with prolonged use.
6. Keep away from heat and dry.
Charging other devices:
- Connect the device to be charged with a cable with a suitable termina�on to the output port in the
powerbank (2xUSB-A, 1xUSB-C,1xDC5525).
Mul�ple devices can be charged using two or all ports at the same �me, but in this case fast
charging is not supported for any of the outputs.
- Charging starts automa�cally.
- Press the ON/OFF bu�on to manually turn the power bank off or on.
- Using a suitable cable with Apple Lightning connector, you can also charge Apple products.
- The power bank has an auto-start func�on when plugged in.
- The power bank supports PD60-65W fast charging technology.
Charge the power bank from an external power source:
- Connect the included USB-C cable to a power source such as your phone's power adapter,
minimum charging voltage 5V/3.0A.
Wireless charging:
- Turn on the power bank using the ON/OFF bu�on and connect the device you want to charge to
the wireless output.
Note: The device you want to charge must support wireless charging.
LED flashlight
To turn on: press and hold the ON/OFF bu�on un�l the LED light turns on. Subsequent short presses
change the light modes:
1. steady full light, 2. strobe, 3. SOS flash (according to Morse code)
Switching off: Press and hold the ON/OFF bu�on un�l the LED light goes out.
Warning and Declara�on:
1. Do not disassemble the device or its accessories.
2. Do not modify, disassemble, open, puncture, remove or otherwise tamper with the rechargeable ba�ery inside the device.
3. Protect from fire, prolonged direct sunlight, and other heat sources to prevent overhea�ng and damage to the device, including the ba�ery inside the device.
4. Protect from contact with water and wet objects, especially when using the equipment.
5. Protect from high voltage equipment.
6. Do not throw or shake the equipment.
7. Do not use chemical cleaners to clean the equipment.
8. This equipment is not intended for use by persons (including children) whose physical, sensory or mental disability or lack of experience or knowledge prevents them from
using the equipment safely.
9. When the appliance is not in use, secure the sockets with safety plugs (if the appliance has them).
10. Stop using this equipment immediately if it is damaged in any way.
11. For safety reasons, use only the original charger and cables designed for this device for charging.
12. In case of igni�on, do not use a water ex�nguisher! If necessary, only a dry powder ex�nguisher is suitable for the product.
13. This product is intended for emergency power supply of electrical appliances only. It is not a full replacement for the permanent DC or AC power supply of household
appliances.
14. This device is designed to supply power to Class II (double insulated) appliances.
15. Altering, damaging or obscuring the logo and nameplate on the equipment is strictly prohibited.
16. When installing the device (if possible), use suitable tools to �ghten all screws.
17. It is strictly forbidden to operate under voltage during installa�on (if possible).
Protect from children!
Ignoring the following safety instruc�ons may result in fire, electric shock, or damage to the equipment
Recycling:
Do not dispose of the product or ba�eries at the end of their useful life as unsorted municipal waste, use sorted waste collec�on points. For more informa�on on recycling
this product, contact your local municipality, household waste management organiza�on or the point of sale where you purchased the product.
Liability for product defects is 24 months according to the Czech Republic Act No.
634/1992 Coll. on Consumer Protec�on. The ba�ery life is 6 months, when under
normal and proper use the ba�ery will not drop below 80% of the ba�ery's real
(rated) power. The LED life�me is 6 months, when, under normal and proper use of
the LED lights, at least 80% of the total number of LEDs in the device are guaranteed
to be lit.
The seller's claim for liability for defects is ex�nguished in the event of:
- Damage due to improper use or use of the equipment in unsuitable condi�ons.
- Failure to comply with the technical specifica�ons and instruc�ons for use of the
equipment.
- A�empts by the user to repair, assemble or dismantle the equipment in an
unprofessional manner.
- Damage to the equipment or any part thereof due to natural elements, e.g.
lightning, water, mechanical damage, etc.
- Damage to the equipment or any part thereof due to unprofessional handling.
The VIKING and TOPDON brands are distributed by BONA SPES s.r.o.
Řepčín 250, Olomouc 77900, Czechia
IČO: 03476774, DIČ: CZ03476774, VAT No.: 03476774
+420 777 109 009, www.best-power.cz, info@best-power.cz
product descrip�on
1. USB-A1 output
2. USB-A2 output
3. DC5525 output
4. USB-C input/output
5. LED light
6. Hook for hanging
7. Ba�ery capacity status LEDs
8. "ON/OFF" bu�on
9. Wireless wireless charging
Capacity
USB-C Input
USB-C Output
2x USB-A Output
Wireless Charging
DC5525 Output
Dimension
Weight
BONA SPES s.r.o.
Package contents:
VIKING power bank
USB-C charging cable
SKADI III
30000mAh/111Wh
5V/3A 9V/3A 12V/3A 15V/3A 20V/3A
PD60W(max)
5V/3A 9V/3A 12V/3A 15V/3A 20V/3.25A
PD65W(max)
5V/3A,9V/2A,12V/1.5 A 18W(max)
15W(max)
12V/2A
173*95*35mm
600g
4 hours
0-45°C
Li-polymer
IP66 (applies only if all input and output
connectors are covered, e.g. by a silico-