VTech vt9118 User Manual

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric
shock and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for
cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool).
5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.
6. Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from overheating, these
openings must not be blocked by placing the product on the bed, sofa, rug, or other similar surface. This product should
never be placed near or over a radiator or heat register. This product should not be placed in a built-in-installation where
proper ventilation is not provided.
7. This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the
type of power supply to your home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking
on it.
9. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short
out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.
10. To reduce the risk of electric shock, do not disassemble this product. If service or repair work is required, contact VTech
Customer Service at 1-800-595-9511. Opening or removing cabinet parts other than specified access doors may expose
you to dangerous voltages or other risks. Incorrect reassembling can cause electric shock when the appliance is subsequently
used.
11. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
12. Unplug this product from the wall outlet:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered
by the operating instructions because improper adjustment of other controls may result in damage and will often require
extensive work to restore the product to normal operation.
e) If the product has been dropped and the cabinet has been damaged.
f) If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock
from lighting.
14. Do not use the telephone to report a gas leak in the vicinity of the leak.

SAVE THESE INSTRUCTIONS

2
INTRUDUCTION
Parts Check List:
1. Handset
2. Base Unit
3. Telephone line cord
4. Battery Pack
5. AC adapter

REPLACING THE HANDSET BATTERIES

1. Use only VTECH battery (80-5074-00-00).
2. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
3. Exercise care in handling batteries in order not to short the battery with conducting materials such as
rings, bracelets, and keys. The battery or conductor may overheat and cause burns.
4. Do not dispose of the battery in a fire. The cell may explode.
The RBRC™ Seal
The RBRC ® Seal on the nickel-cadmium battery indicates that VTech Communications, Inc. is voluntarily
participating in an industry program to collect and recycle these batteries at the end of their
useful lives, when taken out of service within the United States and Canada.
The RBRC ® program provides a convenient alternative to placing used nickel-cadmium batteries
into the trash or municipal waste, which may be illegal in your area.
VTech's participation with RBRC ®
retailers participating in the RBRC ® program or at authorized VTech product service centers. Please call 1-
800-8-BATTERY™ for information on Ni-Cd battery recycling and disposal bans / restrictions in your area.
VTech's involvement in this program is part of its commitment to protecting our environment and conserving
natural resources.
RBRC® is a registered trademark of Rechargeable Battery Recycling Corporation.
To purchase replacement battery packs, call
VTECH Communications at 1-800-595-9511.
In Canada, call VTECH Electronics at 1-800-
267-7377.
1
1. Slide the battery cover off by gently pressing
on the recessed area with a downward motion.
2. Unplug and remove the old battery pack. Don't
put the old battery pack in a trash compactor
or a fire - it could burst.
3. Plug in the replacement battery pack. Place
the battery pack in the compartment with the
battery cord resting on top of it.
4. Replace the battery cover by sliding it into
place.
5. The new battery pack must be charged before
using your telephone. Place the handset in the
cradle of the base unit to allow it to charge for
16 hours. Maximum battery life between
charges is more than 5 hours of continuous
talk time or 6 days of standby.
CAUTION: To reduce the risk of fire or injury, read
and follow these instructions:
makes it easy for you to drop off the spent battery at local
3