Summary of Contents for TEAL TRIANGLE ELITE HOIST
- Page 1 INSTALLATION GUIDE EL I T E H O I ST SCAN THIS QR CODE FOR THE FULL INSTALL VIDEO. SCAN THIS QR CODE FOR EXTRA TIPS FOR INSTALLING THIS PRODUCT. Questions or Concerns? Contact us at: support@tealtriangle.com...
- Page 2 Manufactured for Spire LLC by Tellbe in Vietnam Quantity: 1 WARNING! Elite Hoist is NOT intended for use by any person under the age of 18 years old. You must be over the age of 18 to install or use Elite Hoist.
-
Page 3: Safety Warning/Notes
It is the consumer’ s responsibility to install this system in accordance with all codes, ordinances, and local regulations. When installing the Elite Hoist, it is the consumer’ s responsibility to ensure the structural integrity of the structure it is being mounted to. -
Page 4: Required Tools
HOIST PARTS Strap Bracket With Short Strap and Buckle Strap Bracket With Long Strap Straps Qty 2 REQUIRED TOOLS: Drill Double Pulley Plate Rope 12mm socket 3/16” (5mm) drill bit 3/32” (2.5mm) drill bit Phillips head screwdriver Stud finder Pencil Brake Pulley Plate WEIGHT LIMITS: 75 lbs. - Page 5 Plan and Install Parts Measure the object you are storing and multiply by 0.4 to determine how far apart you will install ceiling plates A and L. For example, a 10 foot object would mean you install the ceiling plates 4 feet apart (10 feet x 0.4 = 4 feet).
- Page 6 Parallel Mounting: Perpendicular Mounting: If perpendicular, 3 joists are required. Choose 3 If parallel, only one joist is required. Mark the center joists that have a gap between them that is closest of the joist near where you will install the ceiling to the distance you found in Step 1.
- Page 7 Assemble rope and strap brackets Place the Strap Brackets (C & D) on the floor below the Pulley Ceiling Plates and orient them so the cross straps face each other. To make sure they don’t turn while installing the rope, connect the cross strap on the Strap Bracket C through the buckle on the Strap Bracket D and tighten to remove the slack Brake Hole 1...
- Page 8 Down and around the pulley on Strap Bracket 1 (C) below Single Pulley Plate (A) Up and around the pulley on Single Pulley Plate (A) Steps 1 & 2 Starting These Steps Knot Future Steps Completed Steps End of Rope is Here Across to Double Pulley Plate (L) and over the top of Pulley 1 (the pulley NOT aligned with the knot hole on the bent tab) Across to Brake Pulley Ceiling Plate (B) and over the top of Pulley 1...
- Page 9 5 (continued) Loop around the brake back into Brake Hole 2. Again, make sure the rope is in the groove of the pulley and under the “teeth.” Over the top of Brake Pulley Plate (B) Pulley 2 across toward Double Pulley Plate (L) Steps 7 &...
- Page 10 Assemble straps and operate hoist Need to know: The free end of the rope coming out of the brake is two ropes that are looped at the end. Each rope can be individually adjusted to straighten the object you are lifting when first setting it, but most of the time you will pull both of them together and treat it as a single rope.
- Page 11 Press down on the buckle release to open it and guide the strap end from the bottom through the slot in the silicone buckle cover and through the opening in the buckle. The buckle must be used with the strap coming up through the bottom and out of the top, it will slip if the strap is going the other way.