Changing Strings - Casio DG-10 Player's Manual

CHANGING STRINGS
Move e Press Down
. Slide
Forward |
1. As shown in the above diagram,
press down on the sensor cover and
move it toward the neck.
Do not use excessive force on "ha
any parts in the sensor assembly.
Hex Wrench (Large)
Pull String Through Notch and Hole
_- -- _——_--
o
—
enue
3. Insert the accessory hex
A. Next, pul the ang through
a y
wrench (large) into the head and
the hole in the headpiece and
turn it counter-clockwise to slide
tighten the headpiece screw while
| R |
FIG-1
the headpiece towards the body.
pulling the string taut.
Next, insert the other hex wrench
Using the large hex wrench, move
3
(small) in the headpiece and
slide the headpiece back into
String J
|
loosen the screw.
position to adjust string tension.
-
oe
"5
Avoid tightening the strings
Wrap String
excessively, as this may lead to
neck warps or other damage.
Also, do not use excessive force
FIG-2
on the neck.
Follow the same procedures to
change all 6 strings.
pulling through a few inches of
string, tie the string as shown in
FIG-2. Next, fix the string tight and
cut off any excess.
_ « a