Table of Contents
Advertisement
SERVICE
EVERY
100 HOURS
Engine Crankease: Change the engine oil in your new tractor at the
50 hour inspection and every 100 hours of operation thereafter. Drain
the oil after the engine has reached normal operating temperature.
Refill the crankcase with four quarts of good heavy duty or premium en-
gine oil and add one extra quart of oil if the filter cartridge is replaced.
SAE 30
—Temperatures consistently above 90° F.
SAE 20
—Temperatures between 90° F. and 32° F,
SAE 20W—Temperatures
between +32° F. and +10° F.
SAE 10W—Temperatures between +10° F. and —10° F.
SAE
5W—Temperatures below — 10° F,
Rear Axle: Remove the rear axle inspection plug (11), Figure 23, and
check the level of the oil. If necessary, add oil. (See SERVICE EVERY
600 HOURS.)
Remove the transmission oil level inspection plug (20),
Figure 23, and add oil, if required. (See SERVICE EVERY 600 HOURS.)
Steering Housing: Check the oil level at the steering gear case plug
(18), Figure 23, and add lubricant as required. Use extreme pressure
gear lubricant SAE 90 in the summer and SAE 80 in the winter.
SERVICE
EVERY
200 HOURS
Oil Filter: Replace the filter car-
tridge with every other engine oil
change and add one quart of en-
gine oil to fill the new cartridge.
Distributor: Remove
the cap and
dust shield. Wipe the cam, the
outside
of the distributor,
the
wires and the coil with a clean
cloth. Apply a portion of distrib-
utor lubricant about the size of a
match
head
on the distributor
Figure 22
cam. Use Ford Distributor Lubri-
Replacing the Oil Filter
cant only.
Cartridge
30
Advertisement
Table of Contents
