Advertisement

You must read and understand the Operating Manual (on the enclosed
CD) and the Dive Computer Safety and Reference Manual (booklet
enclosed) before diving with this product.
Once 10 minutes elapse, while on the suface prior to a dive, operation enters
Power Saver Mode (PSM) until the button is pressed to resume operation.
MAIN >> ALT 1 > ALT 2 > FLY/DESAT > LOG > SET GAS > SET ALM > SET UTL > ID.
Surface Main
(after Dive # 2)
<< WARNING >>
Press the button (B) to activate.

Surface Sequence:

B
B
• Press & release repeatedly
to step through the Surface
Sequence.
• Press & hold (2 sec) to access
Sequence selections.
• Press & release repeatedly to
increase setting values.
• Press & hold (2 sec) to save or
accept setting values.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Aeris A100

  • Page 1 << WARNING >> You must read and understand the Operating Manual (on the enclosed CD) and the Dive Computer Safety and Reference Manual (booklet enclosed) before diving with this product. Press the button (B) to activate. Once 10 minutes elapse, while on the suface prior to a dive, operation enters Power Saver Mode (PSM) until the button is pressed to resume operation.
  • Page 2 << NOTE >> Dives begin automatically upon descent to 5 FT (1.5 M) for 5 seconds. Upon ascent to 2 FT (0.6 M) for 1 second, operation shifts to Surface Mode. Once 10 minutes elapse after surfacing from a dive, another descent is considered a new dive.

Table of Contents