Summary of Contents for Lost Audio B-DAB-760
- Page 1 Lost Audio GmbH & Sumatronic AG B-DAB-760 DAB+ / FM Tuner Modul Conversion for Revox B760...
-
Page 2: Table Of Contents
B-DAB-760 Tuner Modul DAB+/FM Table of contents DAB+/FM tuner General information The rotary wheel Alphanumeric display Station memory system - pearlchains Last listened station Stereo display and signal quality/strength Connecting the antenna Save, listen and customize DAB+ stations DAB+ Sender automatisch speichern „SCAN“... - Page 3 B-DAB-760 Tuner Modul DAB+/FM 5.11 Exiting the settings Menu Save, listen and customize FM stations Saving FM stations automatically „SCAN“ Adding FM stations manually Listen to and change FM stations Changing the FM stations order Delete FM stations individually FM manual operation...
-
Page 4: Dab+/Fm Tuner
Even with difficult reception, you can listen to your favorite stations without any noise. The B-DAB-760 has been designed to be as resistant as possible to any interference that occurs in everyday life thanks to sophisticated filter technologies. This means you can listen to the radio without interference even when reception is difficult. -
Page 5: Alphanumeric Display
B-DAB-760 Tuner Modul DAB+/FM 2.2 Alphanumeric display The new display can show letters, numbers and some special characters. However, to make it look as stylish as the original display, it is limited to 8 characters. This means that certain information is displayed in abbreviated form. Here, original design takes precedence over function. -
Page 6: Last Listened Station
5V, it can be supplied with a maximum of approx. 30mA by the B-DAB-760 module. This supply voltage can be switched on or off via Settings in the DAB+ menu. This is only required for an active antenna and may only be activated in this case. -
Page 7: Save, Listen And Customize Dab+ Stations
B-DAB-760 Tuner Modul DAB+/FM If you receive DAB+Cable via your cable network, you can use the sumaDAB DAB+Cable adapter to convert this signal into normal DAB+ signals and receive them with the DAB module. In this case, an antenna is not required. Cable reception is generally simple and problem-free. -
Page 8: Listen To And Changing Dab+ Stations
B-DAB-760 Tuner Modul DAB+/FM Finally, all radio stations found are saved. A check is also made to ensure that this is not just a data service. The latter are not radio stations, therefore do not transmit music and are therefore automatically deleted during the saving process. It is therefore possible that more stations are displayed during the saving process than are saved at the end. - Page 9 B-DAB-760 Tuner Modul DAB+/FM If you want to swap two stations, for example the station from position 30 to position 5, then first move the station from position 30 to position 5, and only then the station from position 6 (which was previously position 5) to position 31. The position numbers are not displayed, you always use the existing station names as a guide.
-
Page 10: Delete Dab+ Stations Individually
B-DAB-760 Tuner Modul DAB+/FM 4.4 Delete DAB+ stations individually You can delete each stored station individually. To do this, proceed as follows: Briefly press the "STORE IN MEMORY" button below the display. The display now shows "MENU DAB" Turn the wheel clockwise to select the first option "STA SORT"... -
Page 11: Dab+ Dual Channel
B-DAB-760 Tuner Modul DAB+/FM 4.6 DAB+ dual channel If a station is broadcast as a dual channel, the left and right channels transmit a different program, for example different languages. This will be displayed when you display the technical data, but you will of course also hear this immediately. You can switch between the left and right channels using the "STATION BLANK"... -
Page 12: Displaying Data On The Dab+ Station Being Played
B-DAB-760 Tuner Modul DAB+/FM 4.8 Displaying data on the DAB+ station being played If you want to display the technical data for the station you are currently listening to, proceed as follows. In principle, the station should be audible for 30-40 seconds so that the tuner has received all the technical data and can then also display it. -
Page 13: Settings Menu „Menu Dab
B-DAB-760 Tuner Modul DAB+/FM 5 Settings menu „MENU DAB“ You already know the first point of the settings, sorting and deleting channels. Now all the other settings are explained individually. During these settings, the signal quality in the pointer instrument and the stereo lamp are not updated. Depending on the setting, the pointer instrument also drops to the value 0, as the display can be adjusted. -
Page 14: Equalizer Dab+ „Equalize
B-DAB-760 Tuner Modul DAB+/FM 5.3 Equalizer DAB+ „EQUALIZE“ Here you can select one of the predefined equalizer settings that apply to all DAB+ radio stations and that you like. Disable „DISABLED“ Bass boost „BASS BST“ Jazz „JAZZ“... -
Page 15: Drc „Drc
B-DAB-760 Tuner Modul DAB+/FM 5.6 DRC „DRC“ DRC stands for Dynamic Range Control and is only used by a few radio stations. This setting influences the dynamic range of the broadcast radio signal. If the option is activated, the radio station can use this, otherwise not. -
Page 16: Test Tone „Testtone
B-DAB-760 Tuner Modul DAB+/FM 5.9 Test tone „TESTTONE“ You can only navigate through the various test tones using buttons 1 and 5. This is not an actual option that can be saved. This is only a temporary setting to test the audio outputs. -
Page 17: Save, Listen And Customize Fm Stations
B-DAB-760 Tuner Modul DAB+/FM 6 Save, listen and customize FM stations When the DAB+/FM tuner is delivered, no stations are stored on it. To store the FM stations, first switch on the device with the power switch on the far left by tilting it upwards. -
Page 18: Listen To And Change Fm Stations
B-DAB-760 Tuner Modul DAB+/FM Repeat steps 4-5 as often as you like until all stations have been added Then exit this mode by pressing the "MANUAL TUNING" button Exit the Settings menu by pressing the "STORE IN MEMORY" button You can recognize manual mode by the fact that the blue "NOISE REDUCTION" lamp lights up. - Page 19 B-DAB-760 Tuner Modul DAB+/FM If you want to swap two stations, for example the station from position 30 to position 5, first move the station from position 30 to position 5, and only then move the station from position 6 (which was previously position 5) to position 31. The position numbers are not displayed, you always orient yourself of the frequencies of the stations.
-
Page 20: Delete Fm Stations Individually
B-DAB-760 Tuner Modul DAB+/FM 6.5 Delete FM stations individually You can delete each stored station individually. To do this, proceed as follows: Briefly press the "STORE IN MEMORY" button below the display. The display now shows "MENU FM" Turn the wheel clockwise to select the first option "STA SORT"... -
Page 21: Delete All Fm Stations
B-DAB-760 Tuner Modul DAB+/FM 6.7 Delete all FM stations If you want to delete all stored FM stations, press the "STATION BLANK" button for 5 seconds in normal listening mode until "deleted" appears. All stored FM stations are then deleted, meaning that the direct selection buttons are also empty. -
Page 22: Display Fm Rds Radio Text
B-DAB-760 Tuner Modul DAB+/FM 6.9 Display FM RDS radio text The FM RDS radio text can be set in the settings so that it is not displayed at all, only once after each change or permanently. You can restart the display of the radio text at any time (except when set to display the RDS name) by briefly pressing the "CANCEL"... -
Page 23: Rds „Rds
B-DAB-760 Tuner Modul DAB+/FM 7.1 RDS „RDS“ RDS is the Radio Data System, which transmits further information in addition to the music. This is the name of the radio station on the one hand and the slightly longer radio text on the other. You can now decide here what should be displayed. Generally, when you select the stored FM station, the frequency is displayed first and only when this RDS data has been received correctly is it displayed instead of the frequency. -
Page 24: S/N Ratio Threshold For Stereo „Ste Thd
B-DAB-760 Tuner Modul DAB+/FM 7.4 S/N ratio threshold for stereo „STE THD“ Sets the threshold of the signal-to-noise ratio when the tuner should switch between mono and stereo. Values from 0 to 9 can be set. The default value is 4. -
Page 25: Troubleshooting
B-DAB-760 Tuner Modul DAB+/FM 8 Troubleshooting 8.1 Display shows „+5V FAIL“ The supply voltage for an active antenna is switched on, but there is either a short circuit in the antenna cable or the antenna requires too much current. Please check the technical data of your antenna. -
Page 26: Technical Data
B-DAB-760 Tuner Modul DAB+/FM 9 Technical data DAB Frequency range: 174 - 240 MHz DAB Frequency band: 5A – 13F DAB Channels: DAB Sensitivity: -99dBm 87.50 – 108.00 MHz FM Frequency range: FM Frequency band: FM Sensitivity: -106dBm Broadcast type:... - Page 27 B-DAB-760 Tuner Modul DAB+/FM My personal station list 1. _________________ 1. _________________ 2. _________________ 2. _________________ 3. _________________ 3. _________________ 4. _________________ 4. _________________ 5. _________________ 5. _________________ 6. _________________ 6. _________________ 7. _________________ 7. _________________ 8. _________________ 8. _________________ 9.
- Page 28 B-DAB-760 Tuner Modul DAB+/FM...