Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for FITNESS AUDIO DX6-PR
Summary of Contents for FITNESS AUDIO DX6-PR
- Page 1 DX6-PR Operation manual Single-Channel Three Redundancy Digital Receiver...
- Page 2 Single-Channel Three Redundancy Digital Receiver Introduction Thank you for choosing Fitness Audio digital wireless microphone system! For more details, please take a few moments to read this operating manual for thorough understanding of the function and operation of both transmitter and receiver.
- Page 3 Power Button Power On/Off Turn on the DX6-PR by pressing and holding the power button for 1 second. It may take a few seconds for the transmitter and receiver to connect and show solid green signal indicator lights. Power Indicator The power indicator will change color or blink to show the battery status.
-
Page 4: Signal Indicator
DX6-PR Single-Channel Three Redundancy Digital Receiver Signal Indicator SOLID GREEN: The receiver is paired and FLASHING GREEN: the receiver is not communicating with the transmitter. connected to the transmitter, or has gone out of range. If this light remains blinking, the units will have to be paired again. - Page 5 Use the included audio output cable (3.5mm to 6.3mm) to connect the receiver to the mic input (6.3mm) of the amplifier. Be advised that the DX6-PR receiver’s MIC OUT is not compatible with line level inputs labeled as LINE or AUX.
-
Page 6: Tips For Best Results
DX6-PR Single-Channel Three Redundancy Digital Receiver 1. Press and hold the DX6-TF transmitter’s “SYNC” button located under the battery cover until it flashes on the LCD Screen. 2. Press and hold the power button on the PR until the signal LED flashes RED indicating pairing mode, then ... - Page 7 Battery compartment Channel synchronization button Power button Charging contacts Audio input connector for FITNESS AUDIO headset / lavalier / earworn microphone. Battery installation & indicator This transmitter requires two AA batteries to operate. To install, remove the battery cover and insert the batteries into the compartment.
- Page 8 DX6-PR Single-Channel Three Redundancy Digital Receiver Audio mute setting Press the power button to enable MUTE mode and the signal of microphone will not enter the transmitter. Press again to disable MUTE. Under MUTE mode, the transmitter automatically turns off after 5 minutes.
- Page 9 Instructions...
- Page 10 DX6-PR Single-Channel Three Redundancy Digital Receiver...
- Page 11 Instructions MUSICRECEIVER POWER LINK ANT.
Need help?
Do you have a question about the DX6-PR and is the answer not in the manual?
Questions and answers