Sony LBT-D109CD Operating Instructions Manual page 21

You can have the play fade out at the end by designating the play duration. Once the
| time fade is set, it functions twice for editing both sides of a tape. You can change
discs without cancelling this function and use it in any play mode.
arsvepbatem@l0iar-andal-mOlor-]¢-10 ml MDatl>
— Time Fade
Press the EDIT button twice during stop mode,
(or press it once in pause mode).
"TIME FADE" and "A" in the tape indicator appears
in the display.
2 Set the desired play duration, using either the
iq </P> PPI (or I< / PPI) button or
numeric buttons on the remote commander.
a) The ld <4/>> PPI (or <4 / PPI) button —
Useful when using commercial tapes (46-, 54-,
60-, 74- and 90-minute tapes).
Each time you press the 44 <4 /P>p> PPI (or
<< / >>I) button, the play duration for one side
of the tape is displayed as follows.
[ 23.-- <— > 27.-- <——> 30.-- 7
oo oe > )—48,-- s—97.--
b) Numeric buttons (1 ~ 10) — Useful when setting
the time for one side of the tape as you want.
(See page 19.)
You need not press buttons for the seconds,
unless required.
3 Press the > button to start playing.
Before the unit enters pause mode at the set time
with "B' lit in the tape indicator, play starts to fade
out.
To start play for the other side of the ta
Press the > or if button. :
The unit enters pause mode at the set time by fading out 2 —
10 seconds.
When this play ends, time fade is cancelled.
To cancel time fade
Press the EDIT button again.
To display the time remaining until the set time
Press the TIME button twice.
21