Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Fancyyyyy Rung Divisions
- Page 1 RUNG DIVISIONS User Manual Fancyyyyy...
-
Page 2: Table Of Contents
Contents Introduction Panel Layout and Technical Specification Clock Division Bus Outputs Universal Shift Register Output Encoding Signal Flow Installation and Calibration Expanders Limited Warranty Fancyyyyy... -
Page 3: Introduction
Introduction Rung Divisions consists of several parts: a universal shift regis- ter, a “divide by n” pulse divider, dual gate buses, analogue noise, and several logic and binary operations. These functions synthesise an array of predictable and unpredictable digital sig- nals at arbitrary time scale. -
Page 4: Panel Layout And Technical Specification
Panel Layout RUNG DIVISIONS Clock divider and Noise output Bus1 Bus 2 outputs Bus1 Bus2 Noise 1-Bit, 3-Bit, 8- Bit outputs 1-Bit 3-Bit 8-Bit Shift register status LEDs Length control and Bus switches CV input Direction control and CV input... -
Page 5: Clock Division
Clock Division poly-rhythms and interrelated clock signals Rung Divisions has seven integer divide by n pulse dividers. These count the incoming or as sub oscillator / sub-harmonic genera- clock pulses and output a pulse every n tors at audio rate. A clock with PWM applied clocks at divisions between 2 and 8. -
Page 6: Bus Outputs
Fig. 2: Timing diagram of various bus output configurations Clock Divisions can be mixed Poly-rhythmic patterns are easily generated with Rung Divisions through the built in eight at the Bus outputs using the input OR gate buses. Mixing clock divisions eight three-position switches that do not share a multiplication factor (fig. -
Page 7: Universal Shift Register
CV, the CV input is When not using the write switch, the data input for the first bit of Rung Divisions is added to the knob position. derived from a relatively complex logical The read direction of the shift block with parameters taken from the chance, length, and direction controls. -
Page 8: Output Encoding
CV Outputs Chaos To generate chaos with Rung Divisions, the Rung Divisions has three outputs derived from the shift register: a buffered 1-bit gate user must patch the 3-bit or 8-bit output output from the first bit of the register and back to a CV input of the clock source. -
Page 9: Signal Flow
Signal Flow Diagram With chance fully counter-clockwise; an XOR Rung Divisions needs Clock and Data inputs to of the data input and the loop point. function, these inputs can be any signal that •... -
Page 10: Installation And Calibration
Installation and Calibration Rung Divisions has four pin headers on the power protection and should be installed rear of the module. Power should only be with the red stripe facing down aligned with connected to the pin header labelled the mark on the rear PCB. -
Page 11: Expanders
Expanders Coming soon. Fancyyyyy... -
Page 12: Limited Warranty
From the date of manufacture this device is guaranteed for a period of 2 years against any manufacturing or material defects. Any such defects will be repaired or replaced at the discre- tion of Fancyyyyy. This does not apply to; • Physical damage arising for mistreatment (ie dropping, submerging etc).