Advertisement
Note: Please remove the protective films from the LED power display and charging contacts before using it.
Please clean the protective grille of both earbuds if the sound becomes low.
Please clean the magnet charging contact on earbud and charging pin on the charging case with alcohol wipes if the headphones can't be charged.
When the earbuds are in the shut down state and not in the charging case:
If the earbuds are not in the charging case, press and hold either earbud's MFB for 5 seconds to power off both earbuds.
(Before the first use, please ensure that both the earbuds and the charging case are fully charged.)
Note: The earbuds will reconnect to the previously paired device by priority. If you want to pair them with a second device, please disconnect the Bluetooth connection on the paired device. Additionally, if the earbuds are not connected to any devices for over 5 minutes, they will automatically power off.
Note: In single ear mode, the button does not support volume control. Please adjust the volume directly on your device.
When should I reset?
When only one side plays music.
When you can' t use both earbuds together.
When both earbuds fail to pair with each other or occur connection related issues.
How to reset T9?
Before resetting, please ensure that the charging case and both earbuds are not in a low battery status.
The earbuds will alert you with a voice prompt saying 'Low battery, please charge' when the battery level is low. Please place the earbuds inside the charging case, and they will automatically enter charging mode.
Flash red breathing light during charging.
Once fully charged, the light will become red light then go off 10s later.
Note: You can check the power level of the earbuds in the Bluetooth list or in the notification bar after connecting them to your phone.
To avoid charging failures, please clean the charging contacts of the earbuds and the charging pins of the charging case promptly.
After inserting the charging cable into the USB Type-C charging port on the case, the case will automatically start charging.
The LED screen will display an incremental change of power from 0 to 100 during charging. When it reaches 100, it indicates a full charge.
The LED on the case indicates the battery level when you place the earbuds into the charging case or when the case is being charged.
Model No. | T9 |
Bluetooth Version | 5.3 |
Supports Profile | HSP/HFP/A2DP/AVRCP3 |
Charging Port | Type-C |
Input | 5V ![]() |
Battery Capacity | Earbuds: 50mAh 3.7V, 0.185Wh |
Charging Case: 600mAh 3.7V, 2.22Wh | |
Earbuds Battery Life | 8h on single charge |
Charging Time | 1h-1.5h for earbuds |
2h for charging case | |
Transmission Range | 33 feet (with no obstacle) |
Using the wrong battery can cause fire and other hazards (for example, in the case of some lithium battery types).
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the T9 and is the answer not in the manual?
Questions and answers