Page 1
The information provided in this manual was deemed accurate as of the publication date. However, updates to this information may have occurred. To obtain the latest version of this manual, please visit the Crown website at www.crownaudio.com. Trademark Notice: Crown, Crown Audio, and Amcron are registered trademarks of Crown International. Other trademarks are the property of their respective owners.
Important Safety Instructions Importantes Instructions de Sécurité 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Equipment Type: Commercial Audio Mixer-Amplifi ers Family Name: Commercial Audio Family Model Names: 135MA, 160MA EMC Standards: EN 55103-1:1995 Electromagnetic Compatibility - Product Family Standard for Audio, Video, Audio-Visual and Entertainment Lighting Control Apparatus for Professional Use, Part 1: Emissions EN 55103-1:1995 Magnetic Field Emissions-Annex A @ 10 cm and 1 M EN 61000-3-2:1995+A14:2000 Limits for Harmonic Current Emissions (equipment input current ≤16A per phase)
100V). Typical uses are paging, back- ground music, and music-on-hold. The 135MA provides 3 inputs (each with a volume control) and a 35W amplifi er output. The 160MA provides 4 inputs (each with a volume control) and a 60W amplifi er output. 1 kHz...
Commercial Audio Series Mixer-Amplifi ers F. Input Volume Controls: One per input, detented potentiometers with knobs. Four controls in 160MA; three controls in 135MA. G. Tone Controls: Bass and Treble non- detented recessed potentiometers under master output volume control. Bass ±10 dB at 100 Hz, Treble ±10 dB at 10 kHz.
5. On: Routes CH1 to MOH output. 6. On: Routes CH2 to MOH output. 7. On: Routes CH3 to MOH output. 8. On: 15V phantom power. D: Input Connectors 2-4 (160MA) or 2-3 (135MA) Unbalanced line-level RCA-type connectors, summed to mono.
2 Setup 2.1 Installation 2.2 How to Attach the Unit to a Rack CAUTION: Before you begin, make sure 1. Order the optional Rack-Mount Kit from your your mixer-amplifi er is disconnected from Crown dealer. Part no. RM1 is a “single rack mount the power source, with power switch in the kit”...
(two-conductor plus shield), 22-24 gauge cables and connectors. Unbalanced line may also be used but may result in noise over long cable runs. The 135MA and 160MA have two types of input connectors: Phoenix-type and RCA. • Mic/Line Connector (CH1): 5-pin Phoenix-type, balanced, pins 3, 4 and 5 (Figure 2.3).
If you have an external music source connected to the 135MA or 160MA, you can play its music over a phone line while the caller is on hold. Use the connection shown in Figure 2.8 (either 8 ohms or 600 ohms) to connect the mixer-amp to the Music-On-Hold input on your telephone system interface/PBX.
Commercial Audio Series Mixer-Amplifi ers 2 Setup 2.4 Wire Your System Typical input and output wiring is shown in Figure 2.9. INPUTS: For Input 1, connect a microphone or balanced line-level signal to the Input 1 balanced input. Set the Mic/Line switch (DIP switch #1) accordingly.
3.2 Priority Muting If you want a microphone’s push-to-talk switch to mute the background music or other input signals, follow this procedure. On the back of the 135MA or 160MA, 1. Turn DIP switch 2 off. Turn DIP switch 3 on.
Commercial Audio Series Mixer-Amplifi ers 4 Troubleshooting CONDITION: No power to the mixer-amplifi er. POSSIBLE REASON: • The mixer-amplifi er’s Power switch is off. • The mixer-amplifi er is not plugged into the power receptacle. • The mixer-amplifi er’s high-voltage power sup- ply circuit breaker has tripped.
Approval of estimate must be given within 30 days 3. When shipping your Crown product, it is after being notifi ed by Crown Audio Inc. Units still important that it has adequate protection. We in the possession of Crown after 30 days of the esti- recommend you use the original pack material mate will become the property of Crown Audio Inc.
7 Warranty SUMMARY OF WARRANTY Crown International, 1718 West Mishawaka Road, Elkhart, Indiana 46517-4095 U.S.A. warrants to you, the ORIGINAL PURCHASER and ANY SUBSEQUENT OWNER of each NEW Crown product, for a period of three (3) years from the date of purchase by the original purchaser (the “warranty period”) that the new Crown product is free of defects in materials and workmanship.
Page 17
Commercial Audio Series Mixer-Amplifi ers 7 Warranty SUMMARY OF WARRANTY Crown International, 1718 West Mishawaka Road, Elkhart, Indiana 46517-4095 U.S.A. warrants to you, the ORIGINAL PURCHASER and ANY SUBSEQUENT OWNER of each NEW Crown product, for a period of three (3) years from the date of purchase by the original purchaser (the “warranty period”) that the new Crown product is free of...
Page 18
Commercial Audio Series Mixer-Amplifi ers This page intentionally left blank page 18 Operation Manual...