Troubleshooting - Black & Decker LSW40C Instruction Manual

PROBLEM
• Unit will not start.
• Battery will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the location of
the service center nearest you or call the Black+Decker help line at 1-800-544-6986.
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.

TROUBLESHOOTING

POSSIBLE CAUSE
• Battery not installed properly.
• Battery not charged.
• Battery not inserted into charger. • Insert battery into
• Charger not plugged in.
• Surrounding air tempera-
ture too hot or too cold.
8
POSSIBLE SOLUTION
• Check battery
installation.
• Check battery
charging requirements.
charger until green
LED appears.
• Plug charger into a
working outlet. Refer
to "Important Charging
Notes" for more details.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is
connected to a light
switch which turns
power off when you
turn out the lights.
• Move charger and
tool to a surrounding
air temperature of
above 40 degree F
(4.5°C) or below 105
degree F (+40.5°C).
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
®
The RBRC Seal
The RBRC® (Rechargeable
Battery Recycling Corp oration)
Seal on the nickel cadmium,
nickel metal hydride or lithium-
ionbatteries (or battery packs) indicates
that the costs to recycle these batteries
(or battery packs) at the end of their
useful life have already been paid by
BLACK+DECKER. In some areas, it is
illegal to place spent nickel cadmium,
nickel metal hydride or lithium-ion batteries
in the trash or municipal solid waste stream