Bauer 2105C-B Owner's Manual & Safety Instructions page 6

Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Mounting
Verify the mounting surface can support the total
weight of Charger and Battery Packs. Mount
using appropriate hardware (sold separately).
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
When to Charge
1. Charge the Battery Pack when convenient.
2. The Battery Pack does not need to be completely
discharged before charging. It will not develop
a "memory" if charged while still partially full.
Charging
1. Place the Battery Pack on a dry fireproof surface in
a room where the temperature is from 50°‑ 104°F.
Note: If recharging a newly spent Battery Pack,
allow it to cool completely before charging.
2. Examine the Battery Pack. It must be
undamaged, and an 20V, Lithium‑ion type
Battery Pack. Do not charge a cracked,
open, or leaking Battery Pack, or charge a
non-recommended type of Battery Pack.
3. The Battery Pack's terminals are designed to fit
this Charger specifically. If the Battery Pack does
to not fit the Charger properly, do not try to insert it.
Do not force a Battery Pack into the Charger.
4. Plug the Charger directly into a grounded,
120VAC, 60Hz receptacle.
5. Slide the Battery Pack onto the Charger.
Up to six can be installed, only one
Battery Pack charges at a time.
6. While charging, the Battery Pack and Charger
may become warm to the touch. This is
normal, and does not indicate a problem.
Page 6 For technical questions, please call 1-888-866-5797.
Keyhole Hanger
4"
Bottom of Charger
3. To help protect the Battery Pack, it must
be charged when the charge level is near
empty. If a lithium‑ion battery is allowed to
discharge completely, it can be ruined.
Note: If only the Red LED blinks, then the Battery Pack
and/or Charger are not within the correct charging
temperature or there is a problem with the Battery Pack
or Charger. Allow the Battery Pack and Charger
to reach the proper charging temperature.
Note: If the Green and Red LEDs both blink, then the
Battery Pack or Charger may be damaged. Have them
inspected by a qualified technician before charging.
Note: If the both the Green and Red LEDs do not light
then the battery port is defective and should not be used.
7. The Green LED will light continuously
and the Red LED will be off when the
Battery Pack is waiting to charge.
8. The Green LED will light continuously and the
Red LED will blink when the Battery Pack is charging.
9. Both the Green and Red LEDs will light
continually when the battery is charged.
10. Unplug the Charger and disconnect it
from the Battery Pack when finished.
11. Allow the Battery Pack to cool
completely before using.
12. Press the Battery Button to release
Battery Pack from the Charger.
7"
Item 58673