Table of Contents
Advertisement
7
Channels
7.1
About Channels and Switch
Channels
To watch TV channels
• Press . The TV tunes to the TV channel you last
watched.
• Press (Home) > TV > Channels then
press OK.
• Press + or - to switch channels.
• If you know the channel number, type in the number
with the number keys. Press OK after you entered
the number to switch channels.
• To switch back to the previously tuned channel,
press BACK .
To switch to a channel from a channel list
• While watching a TV channel, press OK to open the
channel lists.
• The channel list can have several pages with
channels. To view the next or previous page,
press + or -.
• To close the channel lists without switching
channels, press BACK or EXIT .
Channel icons
After an Automatic channel update of the channel list,
newly found channels are marked with a (star).
If you lock a channel, it will be marked with
a (lock).
Radio channels
If digital broadcasting is available, digital radio
stations are installed during installation. Switch to a
radio channel just like you switch to a TV channel.
This TV can receive digital television standard time
DVB. TV may not work properly with some operators
of digital television , non-compliance with
requirements of the standard in full.
7.2
Install Channel
Antenna/Cable Installation
Search for Channels
Update channels
(Home) > Settings > Install
Channels > Antenna/Cable Installation > Search
for channels
1 - Select Start now and press OK.
2 - Select Update channels to only add new digital
channels.
3 - Select Start and press OK to update channels.
This can take a few minutes.
Quick reinstall
(Home) > Settings > Install
Channels > Antenna/Cable Installation > Search
for channels
1 - Select Start now and press OK.
2 - Select Quick reinstall to install all channels again
with default settings.
3 - Select Start and press OK to update channels.
This can take a few minutes.
Advanced reinstall
(Home) > Settings > Install
Channels > Antenna/Cable Installation > Search
for channels
1 - Select Start now and press OK.
2 - Select Advanced reinstall to do a full re-
installation which takes you through each step.
3 - Select Start and press OK to update channels.
This can take a few minutes.
Service Navigation
(Home) > Settings > Install
Channels > Antenna/Cable Installation > Service
navigation
• If the Service navigation is set to On, You can
browse the primary and secondary channels by
pressing channel and .
• If the Service navigation is set to Off, you can only
browse the primary channels using
channel and .
Digital: Reception Test
(Home) > Settings > Install
Channels > Antenna/Cable Installation > Digital:
reception test
The digital frequency is shown for this channel. If the
reception is poor, you can reposition your antenna.
To check the signal quality of this frequency again,
select Search and press OK.
To enter a specific digital frequency yourself, use the
remote control digit keys. Alternatively, select the
frequency, position the arrows on a number
with and
and change the number
with and . To check the frequency,
select Search and press OK.
17
Advertisement
Table of Contents
