Advertisement
KI
PH: (269) 382-2050
DUST COLLECTOR
IF YOUR GRINDER HAS A DUST COLLECTOR SYSTEM BE SURE TO THOROUGHLY CLEAN THE BASE
AND FILTER AFTER EVERY USE AND OR SWITCHING MATERIALS. DO NOT MIX MATERIALS.
MIXING MATERIALS COULD CAUSE A FIRE.
TRACKING THE BELT
TO TRACK BELT LOOSEN (#41) THEN ADJUST (#10) UP AND OR DOWN. ONCE ABRASIVE BELT IS
CENTERED LOCK (#41) TO KEEP BELT TRACKED. BE SURE THE ABRASIVE BELT FULLY COVERS
THE CONTACT WHEEL. DO NOT SLIP OFF THE ABRASIVE BELT AND RUB THE CONTACT
WHEEL WITH WORK PIECE. THIS WILL RADIUS THE CONTACT WHEEL FACE EDGES AND
RESULT IN POOR BELT TRACKING.
MACHINE HEAD ANGLE
KS390/KS390V CAN BE ADJUSTED FROM HORIZONTAL. LOOSEN CAP SCREW ON TILT BRACKET (#2)
ADJUST THE LEVELING STUD BY LOOSENING (#45) AND ADJUST THE LEVELING STUD UP AND OR
DOWN (#44) TO SUPPORT THE MACHINE HEAD. RE-TIGHTEN CAP SCREW ON TILT BRACKET (#2).
BELT STORAGE
STORE COATED ABRASIVES IN A DRY AND COOL LOCATION.
KALAMAZOO
INDUSTRIES, INC.
KALAMAZOO, MI.
OPERATING INSTRUCTIONS CONTINUED
www.kalamazooind.com
Advertisement
