VocoPro DVG-380K User Manual page 28

Before Getting Started:
It is very important to read the following instructions prior to starting any installation procedures. Doing so will
ensure a correct installation and may save you some time as well.
Protect Against Power Surges
• Connect all external components before you plug any of their power cords into the
wall outlet.
• Turn off the DVG-380K before you connect or disconnect any cables.
• Make sure all cables are properly grounded.
Protect Components from Overheating
• Don't block ventilation holes. Arrange any components so that air can circulate freely.
• Don't stack components.
• If you place the DVG-380K on a stand, make sure you allow adequate ventilation.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the DVG-380K, route all cables down the side of the
back of the DVG-380K instead of straight down the middle of the back of the
DVG-380K.
Important Stand and Base Safety Information
Choose the location for your DVG-380K carefully. If the DVG-380K is placed on a stand or base, ensure that it
is of adequate size and strength to prevent it from being accidentally tipped over, pushed off, or pulled off. This
could cause personal injury and/or damage to the DVG-380K.
Unpacking the DVG-380K
First carefully unpack all of the box contents. You should have found the following items with your new DVG-380K:
• DVG-380K
• Remote Control
• 2 AAA Batteries
• RCA Patch Cable
• User Manual
5
Things to Consider
POWER
SUBTITLE ANGLE OSD OPEN/CLOSE
1 2 3
4 5 6
7 8 9
0 10+
TIME
SETUP PAUSE
TITLE/RETURN STEP STOP ENTER/PLAY
REV FWD PREV NEXT
L/R MUTE ZOOM SLOW
PROGRAM DIGEST REPEAT A-B
PBC LANGUAGE N/P MODE
KEY- KEY+ VOL- VOL+
USER
MANUAL