Table of Contents
Advertisement
When the main PCB or weight sensor is changed, please carry the following 'Zero' adjustment
out for the weight sensor.
Procedure
1.
Plug in power cord
(note: please do not touch the "Clear" key)
2.
Open the door
3.
Place metal turntable
4.
Close the door
5.
Touch 'More/Less' key two times
(No beep sound when key is touched)
6.
Touch 'Weigh Dish' key two times
7.
Touch 'START' key
8.
After 4 sec. display shows 1230
9.
Open the door
10. Place the glass turntable
11. Close the door
12. Touch 'START'
13. After 4 sec. display '1230' stops the flashing
Note: When the display show the error mark "E-" during setting,please try again from the
beginning. In this case, please check if the wiring between weight sensor and main
PCB is correctly connected.
Adjustment Method for Weight Sensor
-19-
Display
Demonstration words
'WELCOME SANYO....'
Flashing '0000'
Flashing '1230'
'1230'
Advertisement
Table of Contents
