nvent CADDY TSR1220 Instruction Sheet

INSTRUCTION SHEET


1
1
Release
Open - Telescope
nVent CADDY Rod Lock
Installation
TSRxxxxxxRL
2
1

Standard Nut Installation

1
WARNING:
1. nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
www.nVent.com and from your nVent customer service representative.
2. nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and/or death, and void your warranty.
5. Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
6. All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are
owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the
right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.nVent.com
L
2
4
3
4
2
Close - Lock
3
2
CFS545_D
*
nVent CADDY SN Nut Recommended For Retrofit, Use
nVent CADDY SNSW For Strut Channel Down Application
Part
TSR1220, TSR122025,
TSR3050M8,
TSR3050M10
TSR122038RL,
TSR3050M8RL,
TSR3050M10RL
TSR1220N
UP
TSR1220R

Max Working Load**

DN
N/LB
DN
N/LB
DN
N/LB
N/LB
** For TSR1220R, See Reverse.
1 OF 2
© 2016-2018 nVent All Rights Reserved
Strut Position
Position
DN position requires the use of the
UP, DN
SNSW
DN position shall not be used with
UP only nVent CADDY Rod Lock part
numbers
UP, DN See page two
SN nut recommended, SNSW
UP, DN
recommended for DN position
Range "L"
UP
(305-400mm)

Point Load

16.25-20in
(406-508mm)
UP
Distributed 12-20in
Load (305-508mm)
Note
Load
12-16in 300lb
(1330N)
200lb
(880N)
300lb
(1330N)