Advertisement
iu]
=
9
c
G
=
10
Preparing
the System
for initial Use
The system needs to be prepared for initial use as described
below. Make sure to follow these instructions.
Inserting Batteries into the Remote Contro
Open the battery compartment
cover.
Lift up the tab { Ww
to remove the cover.
Insert new batteries.
Make sure that the positive and negative termi-
nals of the batteries are oriented as shown.
Close the battery compartment
cover.
=> The Remote Control is now ready for use. For
remote control, point the infrared emitter on the
top of the Remote Control to the infrared
receiver.
Batteries:
2 AA batteries (R6PU)
Battery life: Approximately five months in nor-
mal use (based on manganese
batteries at room temperature)
When to Replace Batteries
* Replace the batteries as soon as possible when the infrared receiver does
not respond properly to remote control operations. Remote control does
not work.
* When placing the Remote Control into the console box, make sure there
is no pressure applied to any of the remote control buttons. Pressure on
any of the buttons will drain the batteries.
Battery Removal
Open the battery compartment cover as described above, and remove the
batteries.
Advertisement
