en Childproof lock
Reset the end time to the current time plus the set
▶
cooking time using the
a After a few seconds, the appliance applies the
change and starts heating up. The cooking time
counts down.
8.5 Setting the time
Once the appliance has been connected to the mains
or after a power cut, the time flashes in the display. The
time starts at "12:00". Set the current time.
Childproof lock
9 Childproof lock
Secure the appliance to prevent children from accident-
ally switching it on or changing the settings.
Notes
¡ The option to set the childproof lock can be activ-
ated in the Basic settings .
¡ After a power cut, the childproof lock will no longer
be active.
Basic settings
10 Basic settings
You can configure the basic settings for your appliance to meet your needs.
10.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display
1
Factory setting (may vary according to model)
10.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold the
1.
four seconds.
a The first basic setting appears in the display, e.g.
.
Use the
or
button to change the setting.
2.
12
button.
Basic setting
Clock display
Signal duration upon completion of a
cooking time or timer period
Acoustic signal when a button is
pressed
Cooling fan run-on time
Waiting time until a setting is adop-
ted
Childproof lock can be adjusted
→ "Childproof lock", Page 12
button for approx.
Requirement: The function selector must be set to the
off
position.
1.
Use
or
to set the time.
Press
.
2.
a The time that is set appears in the display.
Tip: You can define whether the time is shown in the
display in the basic settings.
9.1 Activating and deactivating the
childproof lock
Requirement: The function selector must be set to the
off
position.
To activate the childproof lock, press and hold the
▶
button until
appears in the display.
To deactivate the childproof lock, press and hold
‒
the
button until
Selection
= hide the time
= display the time
= 10 seconds
= 30 seconds
= 2 minutes
= off
1
= on
= short
= medium
= long
= extra long
= 3 seconds
= 6 seconds
= 10 seconds
= no
= yes
Use the
button to switch to the next basic setting.
3.
To save the changes, press and hold
4.
four seconds.
Note: Following a power failure, the factory basic set-
tings are restored.
goes out in the display.
1
1
1
1
1
for approx.