Download Print this page

Viking BALDUR User Manual page 4

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
EN
VIKING BALDUR - User manual
Thank you for choosing a VIKING product.
When using, please refer to the technical specifica�ons of each model, which can be
found in the user manual or on the website www.best-power.cz
Method of use:
1. Please check that the device is fully charged before each use of the power bank. The
capacity and charging status is indicated by the LED display near the power bu�on.
2. The charging �me indicated is for informa�on only and may vary according to the power
of the charging source.
3. Specifica�ons, appearance and descrip�on are subject to change due to product
improvements and updates.
4. Always use a suitable charging cable.
5. Slight hea�ng of the product is normal with prolonged use.
6. Keep away from heat and dry.
7. If the input voltage at the Small Anderson connector is less than 11 V or greater than 28
V, this condi�on will cause the ba�ery to ac�vate under-voltage or over-voltage protec�on
and automa�cally terminate ac�ve processes.
Charging other devices:
Connect the device being charged with a cable with the appropriate termina�on to the
power bank's output port (USB-A, USB-C, 12 V cigare�e output, Big Anderson and M8
terminal).
When connec�ng the device to the M8 terminal, make sure to connect the connectors
correctly.
Mul�ple devices can be charged using two or all ports simultaneously. If you are using
USB-A and USB-C output at the same �me, fast charging is not supported for these outputs.
Charging will start automa�cally. The USB-A and USB-C outputs automa�cally select the appropriate power supply voltage.
Press the power bu�on to manually turn on the power bank.
Using a suitable cable with Apple Lightning connector, you can also charge Apple products. The power bank has an auto-start func�on when plugged in.
The power bank supports QC (18 W max.) and PD (30 W max.) fast charging.
When connected to the 12 V cigare�e output, you can power devices up to 120 W max. such as car refrigerators, fans, lights, etc.
The cigare�e output power supply starts automa�cally. If not, press the power bu�on.
Charging of high power devices:
Output interfaces for this type of power supply are: Big Anderson or M8 type terminals.
Make sure to connect both the Big Anderson connector and the device to the M8 type terminals correctly. Failure to do so will damage the ba�ery pack.
Charging the VIKING BALDUR
Method 1:
Use an adapter/solar panel with a Small Anderson connector.
Recommended charger power: over 80 W (20 V/4 A).
Recommended output of the solar panel: 90 W (18 V/5 A).
Charging �me: It takes approximately 10 hours to fully charge the ba�ery with the 80 W adapter.
Charging �me will vary depending on the solar panel power and light intensity.
Small Anderson connector: red is the posi�ve pole, black is the nega�ve pole, cannot be reversed.
Method 2:
Use an adapter with a Big Anderson connector.
Recommended lithium iron phosphate charger: over 146 W (14.6 V/10 A).
Maximum current is 30 A.
Charging �me: when using a 146 W adapter, it takes approximately 6 hours to fully charge the ba�ery
Method 3:
Using an adapter to connect to the M8 terminal.
Lithium iron phosphate charger recommended: over 146 W (14.6 V/10 A). Time to full charge will be shorter depending on the charger connected.
The maximum current is 30 A.
Charging �me: it takes approximately 6 hours to fully charge the ba�ery with the 146 W adapter.
Terminal M8: red is the posi�ve terminal, black is the nega�ve terminal. Incorrect connec�on will damage the ba�ery.
Warning and Declara�on:
1. Do not disassemble the device or its accessories.
2. Do not modify, disassemble, open, puncture, remove or otherwise tamper with the rechargeable ba�ery inside the device.
3. Protect from fire, prolonged direct sunlight, and other heat sources to prevent overhea�ng and damage to the device, including the ba�ery inside the device.
4. Protect from contact with water and wet objects, especially when using the equipment.
5. Protect from high voltage equipment.
6. Do not throw or shake the equipment.
7. Do not use chemical cleaners to clean the equipment.
8. This equipment is not intended for use by persons (including children) whose physical, sensory or mental disability or lack of experience or knowledge prevents them from using
the equipment safely.
9. When the device is not in use, secure the sockets with safety plugs (if the device has them), charge it at least once every 4 months. and maintain a capacity level of at least 50%.
10. Immediately stop using the device if it is damaged in any way.
11. For safety reasons, use only the original charger and cables designed for this device to charge it.
12. In case of igni�on, do not use a water ex�nguisher! If necessary, only a dry powder ex�nguisher is suitable for the product.
13. This product is intended for emergency power supply of electrical appliances only. It is not a full replacement for permanent DC or AC power supply to household appliances.
14. This device is designed to supply power to Class II (double insulated) appliances.
15. Altering, damaging or obscuring the logo and nameplate on the equipment is strictly prohibited.
16. When installing the device (if possible), use suitable tools to �ghten all screws.
17. It is strictly forbidden to operate under voltage during installa�on (if possible).
Protect from children!
Ignoring the following safety instruc�ons may result in fire, electric shock, or damage to the equipment
product descrip�on
1. Power bu�on
2. Enter Small Anderson
3. Big Anderson's entry
4. M8 terminal (+)
2
5. M8 terminal (-)
6. USB-A output
7. USB-C output
8. Cigare�e outlet 12 V
9. LED display
3
Package contents
- Viking Baldur ba�ery
- MC4/Small Anderson connec�ng cable
- Adapter (op�onal)
Display descrip�on
A - Ba�ery charge level display. One cell here shows
20% of the total ba�ery capacity. If there is no
input/output from the ba�ery, the device will
automa�cally turn off in 68s.
B-IN means charging the ba�ery. OUT means
discharging the ba�ery.
C- Display of the voltage of the en�re accumulator.
D- Displaying the current of the en�re accumulator.
BONA SPES s.r.o.
4
5
1
A
6
7
8
9
B
C
D

Advertisement

loading