Tonna F9FT Assembly Instructions Manual

Advertisement

Quick Links

ASSEMBLY
INSTRUCTIONS
1296/23
FOFT
ANTENNA
=~
IMPORTANT
When opening
the package,
check and compare
al]
parts and hardware
with
enclosed
part list.
ELEMENT ASSEMBLY
For best efficiency,
it is necessary
to keep elements
at some distance
from boom (refer to medalion
n° 2).
1) Place element
in stand-off,
with a smal]
hammer,
gently knock the free
tip of element,
to thrust element through hole (2A and 2B).
2) Slide element
till
proper centering
is reached
(2C).
Operation must be carried
out with utmost
care
to avoid unwanted
bending
of elements.
ANTENNA ASSEMBLY
The red end
indicates
the front
of the antenna,
the black
end,
the
rear,
directors
are counted
up from rear
to front.
Refer to assembly diagram
for proper mounting
:
1) Join the two boom sections
together
(see medalion
n° 3 on diagram).
Use M5 screw n°6 and clamps
n°9 and n°10.
2) Element
assembly
: Each element
is marked with a color
(see general
diagram and color code
in element
table).
Refer
to medalion
3 for proper mounting
of stand-off
on boom.
Make
sure
the bump fits
into the positioning
hole.
CAUTION
The reflector
is the longest element,
each
successive
director
is either
the
same
or shorter
than
the prior director.
Make
sure
directors
are
cor-
rectly mounted
by checking
the color order,
according
to code.
If elements
are not properly mounted,
performance
of the antenna
may be
drastically
reduced.
3) Driven element assembly
:
A short
piece of coay
(RG 213/U),
is factory mounted
on the driven
ele-
ment.
Run the coax
through the 11 mm (7/16 ") hole and attach
the driven
element with the special
screws
n° 7 (see medalion
n® 1).
4) Mount
the supporting
bracket
on the boom,
using M5 screw
n° 8, and
clamps n° 9 and n° 10 (see medalion
n° 5).
ATTACHING
THE FEED LINE
A very high quality,
professional
type,
coax
cable must
be used.
Remernber
the
RG 213/U
exhibits
a loss
of 29 dB/100 m (9,7 dB:100')
at
1,300
MHz.
If better
coax
cable
is available,
use
it. A type N connector
(UG 21 B/U)
must
be mounted
at the end of the short
lengh of coax,
runing out of the
driven
element.
CAUTION
The connector
must
be mounted
ONLY
ONCE
the coax
has been
run
through
the 11 mm (7/16") mounting
hole
!!
This
coax
length
is not randomly
cut
: fro stacking
purposes,
this
length
is an integer number of electrical
half-wavelengths,
and
is the same
on
all
manufactured
antennas.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the F9FT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

1296/23

Table of Contents