Table of Contents
Advertisement
The drain pump can operate shortly
before the appliance fills water.
11.7 Cycle time recalculation
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the cycle time to the laundry you have
put in the drum to have perfect
washing results in the minimum
necessary time.
• The display shows the new time
value.
11.8 Interrupting a programme and
changing a option
You can change only some options before
they operate.
1. Press button Start/Pauze.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pauze again.
The programme continues.
11.9 Cancelling a running
programme
1. Press the button Aan/Uit to cancel the
programme and to deactivate the
appliance.
2. Press the button Aan/Uit again to activate
the appliance.
Now, you can set a new washing programme.
If the ProSense phase is already carried
out and the water filling is already
started, the new programme starts
without repeating the ProSense phase.
The water and the detergent are not
drained out in order to avoid waste.
11.10 The ProSense System load
detection
After touching the Start/Pauze
20
ENGLISH
1. The ProSense System starts the laundry
load detection to calculate the real
programme duration. The indicator
and the time dots flash.
2. After about 15 minutes the display shows
the new programme duration: the
indicator
stops flashing.
The appliance adjusts automatically the
programme duration to the load to
achieve perfect washing results in the
minimum possible time. The programme
duration could increase or decrease.
The ProSense System detection is
carried out with complete washing
programmes only (no skipping phase
selected).
The ProSense System is not available
with all programmes such as :Wol/Zijde
programmes with short cycles and
without washing phase.
11.11 Opening the Lid when the
programme operates
If the temperature and level of the water
in the drum are too high, the
indicator stays on and you cannot open
the lid.
To open the lid proceed as follows:
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.12 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
button:
To open the appliance lid:
goes off and the time dots
CAUTION!
Advertisement
Table of Contents
