Advertisement
FIGURE 15.
Add Lubricant
Here
CONTROLS
Reverse Drive
CHECK GEAR CASE LUBRICANT
After the tiller i« assembled and before gasoline and
oil are added to the engine, check the tiller gear case
for correct lubricant level.
1. Level the tiller by placing wheel yoke in the posi-
-tion shown in figure 15, inset (clevis pin is placed
in the second hole from the top).
2
.
Remove the front pipe plug from tiller gear case.
See figure 15.
THROTTLE CONTROL
The throttle control lever is located in the center of the
handle panel. It controls the engine speed and stops
the engine. See figure 17.
FORWARD DRIVE CLUTCH LEVER
The forward drive clutch lever is located on the left han¬
dle. See figure 17. Squeezing the lever against the han¬
dle engages the forward tine drive. Release the lever
to stop the forward motion.
REVERSE DRIVE CLUTCH LEVER
The reverse drive clutch lever is located on the right
handle. See figure 17. Squeezing the lever against the
handle moves the tines in reverse. Release the lever
to stop the reverse drive.
■^NOTE
3. If lubricant flows from the outlet, lubricant is at the
—correct level. See figure 16.
4. If lubricant fails to flow from the outlet, lubricant
should be added. USE PENNANT OIL EP #35000,
which is available in an 8 ounce squeeze tube.
Order part number 737-0136 from participating
Western Auto Stores.
FIGURE 17.
9
Never engage both the forward and
reverse drive at the same time, or the
engine will stail.
Advertisement
