Download Print this page

PROAIRA HTR40 Owner's Manual page 2

Oscillating ceramic personal heater, 1500w

Advertisement

GENERAL INFORMATION
Reading and Storing the User Manual
future reference, along with purchase receipt and box.
Explanation of Symbols
The words below are used in this user manual, on the oscillating ceramic heater or on the packaging.
This signal word designates a hazard with a high degree of risk which will result in death or
severe injury if not avoided.
This signal word designates a hazard with a moderate risk which may result in death or severe
injury if not avoided.
This signal word designates a hazard with a low risk, which may result in minor or moderate
injury if not avoided.
This signal symbol/word warns of possible damage to property.
This symbol provides you with useful additional information on handling and use.
SAVE THESE INSTRUCTIONS
For Your Own Safety
1.
Always unplug the heater when not in use. Do not pull the cord to unplug the heater.
2.
Keep the air inlet and outlet free from objects. Keep objects at least 3 ft. away from all sides of heater.
3.
Do not place the heater directly below a socket.
4.
Do not use this heater in the vicinity of water including bath, shower, pool, etc.
5.
Keep the heater clean. Do not allow any objects to enter any ventilation or exhaust opening, as this may cause
electric shock, fire, or damage to the heater.
Proper Use
Only use the oscillating ceramic heater as described in this user manual. Any other use is considered improper and may
result in damage to property. The manufacturer or vendor cannot be held liable for damages incurred through improper
or incorrect use.
IMPORTANT SAFEGUARDS
personal injury or loss of life.
READ ALL INSTRUCTIONS
WARNING:
When using electrical appliances, especially when children are present, basic safety
RISK OF ELECTRIC SHOCK!
A faulty electrical installation, excessive line voltage or incorrect operation may result in an electric shock.
WARNINGS!
1.Always use the heater in an upright position.
2.Do not use the heater to dry your laundry (obstructing intake and outlet grills causes danger of overheating).
3.Do not place the heater against walls, furniture, curtains, etc.
4.Cable replacement must only be completed by technicians authorized by the manufacturer.
5.Do not use the heater in rooms less than a 43 sq. ft. area.
(ex. obstruction of air intake and outlet grills, motor turning slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of overheating, then plug the
appliance in again. To avoid injury from unexpected starting or electrical shock, do not plug the power cord into a source
of power during unpacking and assembly. The cord must remain unplugged whenever you are adjusting/assembling the
heater. If any part is missing or damaged, do not attempt to use or plug in the power cord until the missing or damaged
part is correctly replaced.
ELECTRICAL SAFETY AND HANDLING
Always follow basic safety precautions and accident prevention measures when using an electrical
appliance, including the following:
1.Make certain that the power source conforms to the electrical requirements of the heater.
2.The heater is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instructions by a person responsible for their
safety.
3.Do not operate any heater with a damaged cord or after the heater malfunctions, has been dropped or damaged in any
manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment or repair.
4.Unplug power cord before servicing or moving the heater. Always unplug heater when not in use.
6.WARNING: in order to avoid overheating, do not cover the heater.
7.Do not let animals or children touch or play with heater. The air outlet gets hot during operation.
thermostat is in the minimum position.
a bed, where openings may become blocked.
WARNING: DO NOT DEPEND ON THE ON/OFF
SWITCH AS THE SOLE MEANS OF DISCONNECT ING POWER WHEN
SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE
POWER CORD.
Locate the power cord so the heater or other objects are not resting on it. Do not run power cord under carpeting. Do
carpets.
not be tripped over.
12.This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the handle
when moving this heater. Keep combustible materials. such as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9m) from the sides and rear.
13.This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub or
other water container.
14.Do not use heater outdoors.
-2
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK.DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED
CONTROL DEVICES SUCH AS DIMMER SWITCHES, TIMERS OR
TRIACS.
WARNING:
This product is equipped with a polarized plug (one blade is wider than the other
Always plug heater directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap
(outlet/power strip).
Cleaning
IMPORTANT!
Do not immerse heater in water! Clean the heater grills with the vacuum
brush attachment on your vacuum cleaner. This will remove lint and dirt from the inside of the heater.
DO NOT ATTEMPT TO TAKE HEATER APART.
Clean the body of the heater with a soft
cloth.
CAUTION:
Do not use gasoline, benzine, thinner, harsh cleaners, etc. as they will damage the
heater. NEVER USE ALCOHOL OR SOLVENTS.
STORAGE:
Store the heater with these instructions in the original carton in a cool, dry place.
OPERATING INSTRUCTIONS
This appliance requires no installation. It should be used solely as a portable appliance. Portable appliances are not
suitable for use in a bathroom.
Thermostat Knob
· Turn the thermostat knob clockwise to increase the thermostat setting temperature.
· Turn the thermostat knob counterclockwise to decrease the thermostat setting temperature.
Oscillation Button
Control Knob
II • High heat 1,500 W
I • Low heat 750 W
FAN • Fan-only mode with no heat
Technical Data
Product description:
Oscillating Ceramic Heater
Model/Product code:
HTR40
Input voltage:
120 V / 60 Hz
Power:
1500 W
Dimensions:
7.8W x 6.1D x 11H in
Visible cord length:
5.9 feet
re.
t a
turn

Advertisement

loading