Step 3. Start/Stop Engine - NorthStar e300 Owner's Manual

Table of Contents

Advertisement

Inspect Fuel System/Check for Leaks
Inspect the engine fuel system and check for leaks
before each use.
Do not start engine until all needed repairs have been
completed.
WARNING
Fuel Leak Hazard
Gasoline fuel is highly explosive and fuel leaks
can result in fire or explosions. You can be
burned and seriously injured if the fuel system is
not properly hooked up or there is a fuel leak
when you start the engine.
Inspect the entire fuel system. Look for:
signs of leaks or deterioration
chafed or spongy fuel hose
Perform Scheduled Maintenance, As needed
Make sure that any other regular maintenance
has been performed as prescribed in this manual
in the "Maintenance Schedule Summary" section.
Refer to the engine Owner's manual for engine
maintenance instructions.
Starting the Engine (Recoil Models Only):
114593 (804313) and 114594 (804314):
1. Adjust the throttle speed to maximum speed.
2. Toggle the engine switch to the "ON" position.
(NorthStar illuminated logo will illuminate fuel pump
will power on).
3. Pull the recoil to start the engine.
Operation
Do not release the starter handle suddenly after starting
to avoid it from recoiling back and hitting the engine. It
should be released slowly with the rebound of the
starter rope.
• For electronic fuel injection (EFI) engines,
no altitude adjustment is required.
Starting the Engine (Electric Start)
114656 (804315:)
Note: A 12V 14Ah (minimum) battery is required for
operation of this engine.
Connect the positive wire (+) to the positive pole (+)
of the battery. Connect the negative wire (-) to the
negative pole (-) of the battery.
1) Toggle the engine switch to the "ON" position.
(Engine Start/Stop button will have solid red
illumination). This will allow the engine to start.
Alternatively, pull the recoil to start the engine.
15
CAUTION

Advertisement

Table of Contents
loading

This manual is also suitable for:

E420114593114594114656

Table of Contents