Tricity Bendix CH 605 Operating And Installation Instruction page 7

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Confd
The cooker hood functions are controlled by two
slide switches and a change-over slider control.
The two slide switches, which are located on the
right hand side in the front fascia panel, control
the fan speed and worktop illumination.
The change-over slider control is located inside
the cooker hood behind the inlet grille immedi¬
ately in front of the lamp assembly.
Ensure the hood is plugged in, or wired in
and the power supply is switched on.
The switch marked with the lamp symbol and
numbered 0-1 controls the worktop lighting. Po¬
sition -1 indicates the light is operating.
The switch marked with the fan symbol and
numbered 0-1-2-3 controls the fan speed, -1 Low,
-2 Normal and -3 Boost.
Position -1 Should be selected when sim¬
mering or when using one pan.
Position -2 Should be selected for normal
cooking up to four pans.
Position -3 Should be selected when fry¬
ing or cooking food with strong
odour.
In the recirculation position, slider towards the
charcoal filter, air enters the cooker hood, passes
through the grease and charcoal filter and out
through the holes in front of the casing top panel.
To convert the hood from extraction to recircu¬
lation open the metal inlet grille and slide the
change-over control to the right. Remove the
thumb screw from the motor support. Take the
charcoal filter and place it over the motor sup¬
port and secure by passing the thumb screw
through the hole in the filter and into the capti¬
vated nut in the centre of the motor support.
In the ducting position, with the slider away from
the charcoal filter, the air passes through the
grease filter and out through ducting to the at¬
mosphere. When the ducting position is selected,
the (optional) charcoal filter is not required.
NOTE: The hood is more effective when used in
the extraction (ducting) mode, therefore this
position should be selected during the warmer
months of the year when no room heating is
required. When the room is being heated if the
recirculation position is selected heat will not be
wasted.
To obtain the best performance it is advisable to
switch on the cooker hood a few minutes before
you start cooking and leave it running for 15
minutes after finishing.
7