Warranty; Technical Data - Bresser BR Series Instruction Manual

NOTE:
Do not unscrew the screw completely.
2. Place the pre-mounted daylight lamp with the stand
connection opening (10) onto the spigot adapter (S) on the
lamp stand (F).
3. Hold the daylight lamp firmly and simultaneously turn the
wing screw on the stand connection clockwise to secure the
lamp to the stand.
POWER SUPPLY
(FIG. 4)
1. Plug the mains plug (12) on the power cable (11) into the
socket (100-240 V).
2. Tilt the light switch(es) (5) to the 'I' position to switch on
the light.
2. Tilt the light switch(es) (5) to the '0' position to switch off
the light.
NOTE:
Depending on the model, the lighting is controlled via one or
more light switches. With several switches, the lamps can be
switched separately or in pairs. Please refer to the diagrams
in Fig. 4a.
OVERVOLTAGE PROTECTION / RE-
PLACING THE FUSE
An overvoltage in the connected mains current can lead
to a sudden failure of the device. This indicates that the
overvoltage protection mechanism was activated by the built-
in fuse. The fuse must then be replaced in order to continue
using the device. Proceed as follows:
1. Turn the cover of the fuse compartment (8) labelled 'FUSE' in
the direction of the arrow/counterclockwise and remove it.
2. Remove the fuse (P) (small glass tube) from the holder in
the cover and replace it with a new fuse of the same type.

TECHNICAL DATA

Item no.
Model variant(s)
Power supply
Number of lamp
sockets per light
Number of switches
per light
Overvoltage
protection
Light source
Number of softboxes
per set
Number of light
stands per set
(FIG. 4)
F001903 F001906
V1 + V4 V4
100-240V mains power, over permanently installed power cable
1x1 + 2x4 3x4
2x2 + 1x1 3x2
When replacing, pay attention to the type marking on the fuse!
(energy-saving spiral lamps or adequate LED lamps recommended)
3 3
3 3
IMPORTANT:
Make sure to use the same type as stated on the fuse!
3. Reinsert the cover with the new fuse into the fuse
compartment and tighten it in the opposite direction of the
arrow/clockwise.

WARRANTY

The regular warranty period is 2 years and begins on the day
of purchase. To benefit from an extended voluntary warranty
period as stated on the gift box, registration on our website
is required.
You can consult the full warranty terms as well as information
on extending the warranty period and details of our services
at www.bresser.de/warranty_terms.
CE DECLARATION OF CONFORMITY
Bresser GmbH has
Conformity" in accordance with the applicable guidelines and
corresponding standards. The full text of the CE Declaration
of Conformity is available at the following link:
www.bresser.de/download/br_softbox_daylights/CE/
br_softbox_daylights_CE.pdf
DISPOSAL
Dispose of the packaging materials according to type.
Information on proper disposal can be obtained from your
municipal waste disposal service or environmental agency.
Do not place electrical appliances in household waste!
According to the European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment and its transposition into
national law, used electrical equipment must be collected
separately and recycled in an environmentally sound manner.
F001998
V4
2x4
2x2
yes, via F3A fine fuse (glass tube)
Lamps with E27 thread
2
2
prepared a "CE Declaration
F001917 F001918
V5 V5
3x5 2x5
2 2
3 2
3 2
EN
of
7