Exit Light EL-CST Installation Instructions

INSTALLATION INSTRUCTIONS FOR
LED EMERGENCY LIGHT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical, basic safety precautions should always be followed including the following.
1. Disconnect power at fuse or circuit breaker before installing or servicing.
2. Do not use outdoors.
��3� • Do nofinolf nTinnaz- a � r a- o u- s � l ocations, or near gas or electnc neaters.
4. Do not let power cords touch hot surface.
5. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized
personnel.
6. The use of accessory equipment not recommend by the manufacturer may cause an unsafe condition.
7. Do not use this equipment for other than intended use.
8. All servicing should be performed by a qualified personnel only.
9. Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS
MAINTENANCE
Battery have to recharge if product keep in stock over 9 months, detail manual refer'BA TTERY STOCK AND RECHARGE
GUIDELINE".We recommend that the equipment is tested regularly in accordance with local codes. Replace the batteries
as needed if discharge time do not achieve 90 minutes.
OPERATION
Press the test button. The LED heads will turn on and the LED indicator will turn off. Release the test switch,LED indicator will
tum on and the LED heads will tum off.
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator does not illuminate, check the following:
1. Check AC supply - verify that unit has 24 hours AC supply.
2. Unit is shorted or battery is not connected.
3. Battery discharge. Permit unit to charge for 24 hours then re-test.
4. If above trouble shooting hints do not solve you problem, contact factory for assistance.
IMPORTANT SAFEGUARDS
Use Flexible Conduit Only
Page 1 of 2