Advertisement
FIGURE 1
\
FIGURE 2
MOUNTING
~-BRACKET
TAPERED
MOUNTING
ROD
ASSEMBLY
MOUNTING TO TRACTOR FRONT
1. Assemble your Tractor Front Mounting Bracket (Fig. 2)
to tractor per instructions with Bracket. Save Mounting
Rod and Retainer Spring for other applications.
2. Position Tote Box upside down on floor (Fig. 1 ).
3. Remove Retainer Springs from Mounting Rod and remove
Rod.
4. Rotate Mounting Bracket 180° to position shown in Fig. 1.
Insert Mounting Rod in same location removed in step 3
and secure with Retainer Springs.
5. Set Tote Box upright and slide Mounting Bracket Pins into
slots of Tractor Front Mounting Bracket (Fig. 2).
6. Remove Retainer Springs from Tapered Mounting Rod
(Fig. 1) and remove Rod.
7. Line up upper holes in Tractor Front Mounting Bracket
with holes in Mounting Bracket, insert Tapered Mounting
Rod (removed in step 6) thru holes and secure with Retain-
er Springs (Fig. 2).
8. Save Hitch Mast and Tube (shown below) for use when
mounting Tote Box to tractor rear.
MOUNTING TO TRACTOR REAR
1. Assemble your Manual or Electric Three Point Hitch to
r·,.
tractor per instructions with Hitch.
\:;,~)
2. Position Tote Box upside down on floor (Fig. 1 ).
3. Remove Retainer Springs from Mounting Rod and remove
Rod.
4. Rotate Mounting Bracket 180° to position shown in Fig. 1.
Insert Mounting Rod in same location removed in step 3
and secure with Retainer Springs.
5. Set box upright.
6. Remove Retainer Springs from Tapered Mounting Rod
(Fig. 1) and remove Rod.
7. Position Hitch Mast and Tube in Mounting Bracket (Fig. 3)
with end of Hitch Mast (without hole) inserted into slot of
Mounting Bracket. Line up holes in Tube with holes in
Mounting Bracket, insert Tapered Mounting Rod and secure
with Retainer Springs.
8. Place Hitch Mast in Three Point Hitch Clevis and secure
with Clevis Pin and Retainer Spring.
9. Position Lower Hitch Bars of Three Point Hitch over
Mounting Bracket Pins and secure with Retainer Springs.
10. Level Box from side to side.
a. Loosen Lift Link Locknut (Fig. 3).
b. Turn Link Adjustment
Sleeve counterclockwise to
lengthen linkage.
c. After adjusting, tighten Locknut against Link Adjust-
ment Sleeve.
11. Level Box from front to rear.
-2-
a. Loosen Adjusting Screw Locknut located against Trac-
tor Clevis.
b. Turn Adjusting Screw clockwise to lengthen the top
linkage.
c. After adjusting, tighten the Adjusting Screw Locknut
against the Tractor Clevis.
Advertisement
