Download Print this page

WBM 6405D User Manual page 2

2 in 1 electric bug zapper

Advertisement

2 IN 1
ELECTRIC BUG ZAPPER
Item NO. 6405D
The Parts Subsidiary: Electric Bug Zapper /
USB Cable / Charging Base /
User Manual.
Three layered safety mesh
Inside hidden
LED lamp beads
Working Indicator Light
Power Indicator Light
100% Power
Working
Indicator Light
75% Power
50% Power
25% Power
High-voltage button switch
Press down to manually
kill mosquitoes
USB Cable
Product instructions
Conventional anti-bug method: Push the power switch on the right
side of the product to the ON1 position, press and hold the
high-voltage button switch, and the high-voltage working indicator
light will be on. At this time, the metal net is equipped with high-volt-
age, wave the electric bug swatter to make the metal net contact
with bug, and the bug will be killed immediately. When the button
switch is released, the work indicator goes off. At this time, there is
still residual voltage on the metal mesh. Do not touch the metal
mesh. The voltage will be automatically eliminated after a few
seconds;
Intelligent anti-bug method: Push the power switch of the product to
the ON2 position. At this time, the LED bug trapping purple light
glows, the grid has high voltage, and then insert the tail of the
electric bug swatter into the USB charging base of the product.
When mosquitoes and other harmful flying insects are attracted by
the purple light on the product and fly to the electric mosquito grid,
they will be killed when touched.When using the bug trap mode, the
connection of power supply is required to use the anti-bug light
function;
Turn OFF the anti-bug function ofthe product: Just push the power
switch to the OFF position
ON2
ON1
Power switch
OFF
Mode selection
OFF / ON 1 / ON 2
Shutdown State
Parameter
Rated charging voltage
Charging base
Rated charging current
USB cable socket
Product Size
ON2
ON2
ON1
ON1
OFF
OFF
Bug Racket
Insect Killing Lamp
Operation Mode
Operation Mode
5V
Output voltage
3000V
1A
Rated capacity
1200mAh
21.2 x 8.6 x 3.7 inch
Charging time
4H
Precautions
When the electric bug zapper is working, the metal mesh surface
has high voltage! Keep away from children, beware of electric
shock to children,do not touch the metal mesh surface with your
hands or hand-held metal objects, high voltage danger, please pay
attention to safety!
Do not use this product in places where flammable gas or explosive
dust may exist, and do not often use metal and other conductive
objects to spark on the metal net;
After use, please push the power switch to the OFF position;
In order to guarantee the service life of the battery, if there is no
obvious effect of hitting the killing bug during use, or the bottom
battery power indicator flashes, it means that the battery power has
basically been used up.please stop using and recharge products in
time,When the voltage of the lithium battery is lower than 2.8V the
low-voltage protection function of the product will cause the product
to enter the protection state ano appear to be unable to work, and
it must be charged before use;
If it is not used for a long time, the product should be replenished
once every three months for about 4 hours The product should be
stored in a ventilated, dry place with a relative humidity of less than
80%. There should be no corrosive chemicals around;
Do not wipe with wet towels or rinse the bug corpses on the net
surface with water, you can use a soft brush with long hair or tap a
few times to fall off (bug carcass may cause a short circuit on the
meta mesh surface, damage the electric mosquito swatter, please
clear it in time);
Please do not slap other hard objects or pinch the mesh surface of
the product to avoid damaging the metal mesh surface;
Please operate in strict accordance with the requirements and
precautions of the instructions, and do not disassemble at will. The
company shall not be liable for any adverse consequences caused
by illegal operation.
Tips: Due to the built-in low-voltage protection function of the product, when the 25%
power indicator flashes or the power indicator does not light up on the product during use,
it means that the battery has basically run out. Please stop using and charge it in time.
And you need to push the power switch on the product to the "OFF" position to charge.

Advertisement

loading