Table of Contents
Advertisement
en Basic operation
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 12
a The appliance begins to cool.
Set the required temperature.
2.
→ Page 16
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
the housing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
¡ The temperature in the appliance
varies due to the following condi-
tions:
– How often the appliance is
opened
– Load capacity
– Temperature of newly stored
food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appli-
ance
Disconnect the appliance from the
▶
power supply. Unplug the appli-
ance from the mains or switch off
the circuit breaker in the fuse box.
16
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
To reduce the temperature, turn
1.
the temperature controller in the
direction.
Select a very cold setting only tem-
porarily; if the door is opened fre-
quently or before placing large
quantities of food in the refrigerator
compartment.
To increase the temperature, turn
2.
the temperature controller in the
direction.
Note: At a room temperature above
32 °C, turn the rotary selector to
.
At a room temperature below 16 °C,
turn the rotary selector to
Setting the one-star freezer
compartment temperature
In order to set the one-star freezer
▶
compartment temperature, change
the refrigerator compartment tem-
perature.
The refrigerator compartment tem-
perature influences the one-star
freezer compartment temperature.
Refrigerator compartment temper-
atures that are set to warm gener-
ate warmer one-star freezer com-
partment temperatures.
.
Advertisement
Table of Contents
