Troubleshooting - Panasonic TX-24MSW504 Operating Instructions Manual

J Applicable HDMI features
● Input audio signal:
2ch Linear PCM (sampling frequencies - 48 kHz,
44.1 kHz, 32 kHz)
● Input video signal:
"Input signal that can be displayed" (p. 10)
Match the output setting of the digital equipment.
USB Flash Memory
For playing back in Media Player
Format: FAT32
Compliance:
Supports only USB1.1 or USB2.0 standard.
Maximum USB capacity supported is 1TB.
Note
● Data modified with a PC may not be displayed.
● Do not remove the device while the TV is accessing
data. Otherwise this can damage the device or TV.
● Do not touch the pins on the device.
● Insert the device in the correct direction. Otherwise
this can damage device or TV.
● Electrical interference, static electricity, or erroneous
operation may damage the data or device. Panasonic
is not liable for any deterioration or damage of data or
device during operations with the TV.
● It is recommended to connect the USB Flash Memory
directly to the TV's USB port.
● Some USB devices or USB HUB may not be used with
this TV.
● You cannot connect any devices by using the USB
port.
● Additional information for USB devices may be on the
following website. (English only)
http://panasonic.jp/support/global/cs/tv/
14
English

Troubleshooting

Before requesting service or assistance, please follow
these simple guides to resolve the problem. If an error
message appears, follow the message's instructions.
If the problem still persists, please contact your local
Panasonic dealer for assistance.
Screen
Red, blue, green or black spots on the screen.
This is the characteristic of liquid crystal panels. The

liquid crystal panel is built with very high precision
technology. Occasionally, a few non-active pixels
may appear on the screen as points of red, green,
blue or black. This does not affect the performance of
your TV and it is not a quality problem.
Chaotic image, noisy.
Set [Noise reduction] in the [Picture] menu to remove

noise (p. 11).
Check nearby electrical products (car, motorcycle,

fluorescent lamp).
No image is displayed.
Check the settings of [Contrast] or [Brightness] in the

[Picture] menu (p. 11).
Check the TV is in AV mode. If the TV is in AV mode,

check the selected input mode match the output of
the external equipment (p. 12).
Unusual image is displayed.
Turn the TV off with Mains power On/Off switch

(p. 10), then turn it on again.
Pictures from equipment connected via HDMI are
unusual.
Check the HDMI cable is connected properly.

Turn the TV and equipment off, then turn them on

again.
Check an input signal from the equipment.

Use equipment compliant with EIA/CEA-861/861D.

Sound
No sound is produced.
Check the sound mute setting (p. 11) and volume.

Low level or distorted sound.
Sound signal reception may be deteriorated.

Sound output via HDMI connection is unusual.
Set the sound setting of the connected equipment to

"2ch L.PCM".