Table of Contents
Advertisement
TO DUB AUDIO
You can add a sound such as music or commentary on the
tape on which the video signal has already been recorded,
The new sound is recorded on the audio channel 1, and
when the new sound Is recorded, the previous sound will be
erased.
= Nb
Sound
LINE IN]
Source
CH+t
MIC CH-4
g ae
Operation
1, Turn the power on.
2. Insert a recorded video cassette.
3, Press the DUB/CH-1 button.
4. Adjust the audio recording level.
5, Press the DUB/CH-1 and PLAY buttons simultaneously.
The recorder enters the audio dubbing mode.
To stop dubbing, press the STOP button.
elf both a microphone and another audio source are con-
nected simultaneously, only the sound from the microphone
will be recorded.
e@When
a microphone
is used,
avoid
pointing
the
microphone at the monitor or turn the sound volume on the
monitor iis to piprevent & acoustic feedback a whistle-like
sound).
:
To record sound on the middle of the tape
Play the tape to the polnt at which sound is to be added and
press the PAUSE button to stop the tape momentarily.
Press the DUB/CH-1
button, then the PAUSE button again.
The recorder will enter the audio dubbing mode.
18
TAPE DUPLICATION
The DUB IN and DUB OUT connectors of the VO-5800PS are
for duplicating a video signal. If the player has similar type.
duplicating
connectors,
connect
the recorder and player
with a VDC-5 dubbing cable (optional).
When the DUB IN connector Is used, be sure to set the IN-
PUT SELECT switch to DUB.
When
the DUB connector Is used, the E-to-E mode picture
'on the monitor connected to the recorder may rol vertically
when the player Is tn the pause and search mode.
TO HEAR THE SOUND BEING RECORDED
When a video monitor is connected to the TV connector or
the AUDIO MONITOR jack, or when headphones are used,
set the AUDIO MONITOR switch to the appropriate position
to hear the desired sound.
AUDIO
MONITOR
CHA
ao
tohear the sound on the channel
7 only
MIX z aux. 10 hear the sound on both channel 1 and
CH-2
2 simultaneously
'™ to hear the sound on the channel 2 only
The LINE CH-1 and CH-2 OUT jacks output the sound on
channel 1 and channel 2, réspectively. They are not affected
by the setting of the AUDIO MONITOR switch.
@The
volume of the headphones
can be adjusted
by the
HEADPHONES
LEVEL control.
ERASING ©
Recorded. material.
ls. erased.
automatically.. when
new
material is recorded, To erase recorded material without
recording new material, follow this procedure:
1. Disconnect afl Input connections to the TV, VIDEO
IN,
DUB IN, MIC, LINE GH-1 and CH-2 IN connectors,
2. Insert a video cassetie with a red button on the bottom.
3.Set the machine
in the record mode. The recorded
material will be erased.
Advertisement
Table of Contents
