Table of Contents
Advertisement
13.2 Removing foreign objects
Make sure that pockets are empty and all
loose elements are tied up before
running your cycle. Refer to "The laundry
load" in "Hints and tips".
Remove any foreign objects (such as metal
clip, buttons, coins, etc) that you may find in
the filters and the drum. Refer to "Cleaning
the drum", "Cleaning the drain pump" and
"Cleaning the inlet hose and the valve filter"
paragraphs. If necessary, please contact the
Authorised Service Centre.
13.3 External cleaning
Clean the appliance with mild soap and warm
water only. Fully dry all the surfaces. Do not
use a scouring pads or any scratching
material.
CAUTION!
Do not use alcohol, solvents or chemical
products.
CAUTION!
Do not clean the metal surfaces with
chlorine-based detergent.
13.4 Descaling
If the water hardness in your area is high
or moderate, we recommend that you
use a water descaling product for
washing machines.
Regularly examine the drum to check for
limescale.
Regular detergents already contain water
softening agents, but we recommend to run a
cycle with an empty drum and a descaling
product.
Always follow the instructions that you
find on the packaging of the product.
13.5 Maintenance wash
With the low temperature programmes it is
possible that some detergent stays in the
drum. Perform a maintenance wash regularly.
To do this:
• Remove all laundry from the drum.
• Select the cotton programme with the
highest temperature with a small quantity
of detergent.
13.6 Lid seal
Regularly examine the seal and remove all
objects from the inner part. Clean it when
needed, using ammonia cream cleanser
agent without scratching the seal surface.
Always obey the instructions that you find
on the packaging of the product.
13.7 Cleaning the drum
Regularly examine the drum to prevent rust
particles.
For a complete cleaning:
1. Clean the drum with special products for
stainless steel.
Always follow the instructions that you
find on the packaging of the product.
2. Run a short cotton programme at high
temperature or use if is available
programme Nettoyage Tambour. Add a
small quantity of powder detergent into
empty drum, in order to rinse out any left
residues.
ENGLISH
27
Advertisement
Table of Contents
