Storage - Scotts LM71313S Owner's Manual

MAINTENANCE
4. Thread the lines through each corresponding ferrule. Ensure that both ends of the line are
straight and are even in length (Figs. 13 – 14).
Fig. 13
Fig. 14
5. Refer to the above steps to replace another cutting line (Fig. 15)
Fig. 15
NOTE: There is a built-in line cutter that will cut and trim the lines slightly longer than desired.
WARNING! For optimal performance, use only replacement cutting lines designed specifically for this
electric leaf mulcher. Monofilament lines having a maximum diameter of 0.09 in. (2.3 mm) and a
maximum length of 13.8 in. (351 mm) long may be temporarily substituted, but this is NOT
recommended. Use of thicker lines, lines made of substitute material, or lines greater than 13.8 in.
(351 mm) long may result in permanent damage to the motor and will void the manufacturer's
warranty. Immediately replace any worn parts of the spinner head.

STORAGE

When storing the electric leaf mulcher at the end of the season, disassemble the unit and stack the
parts in the following order:
1. Place the funnel into the box.
2. Fit the funnel handle into the funnel.
3. Place the legs in the box beside the funnel.
13
Model LM71313S