Summary of Contents for Zaiput Flow Technologies BPR-1000
- Page 1 Zaiput Flow Technologies Separation Made Simple Instruction Manual BPR-1000 Zaiput Flow Technologies 101a 1 Ave, Waltham, MA - 02451 ph/fax 617-714-9806 Email: sales@zaiput.com http://www.zaiput.com...
- Page 2 While using BPR-10, the specifications of this manual must be followed. “Zaiput” and Zaiput’s logo are Trademarks of Zaiput Flow Technologies LLC. The device is covered by issued and pending patents in several jurisdictions.
-
Page 3: Table Of Contents
Table of Contents General Information ..........................1 1.1. Box Content ............................ 1 1.2. Technical Data ..........................1 1.3. Principle of operation ........................1 1.4. Device Schematics .......................... 2 Safety Precautions ..........................2 Setup & Operation ..........................2 3.1 Methods of operation ........................... 4 3.3 Technical Notes &... -
Page 4: General Information
General Information This manual provides information about the installation, operation, and safety precautions of Zaiput Flow Technologies laboratory scale Back Pressure Regulator (BPR-1000). We recommend keeping this manual near the device for quick and easy reference. The device is designed for the maintenance and use of a user selected value of back-pressure in a flow system or batch vessel. -
Page 5: Device Schematics
• Setup & Operation The BPR-1000 has four ports: an inlet port, an outlet port, and two charging ports to set the pressure. Please note the directionality of the inlet and outlet ports denoted by the arrow on the side of the device. - Page 6 Charging ports: There are two different connection available to fill with compressed air the top cavity of your BPR-1000: Specialty fitting specifically selected for the BPR-1000 that contains a valve to seal off the device once fille dup with compressed air. The dedicated connector is provided with the device.
-
Page 7: Methods Of Operation
3.1 Methods of operation Method 1: Set it and Forget it To pressurize, connect your pressurized gas source to the top of the BPR. Open the valve by turning the small valve counterclockwise with a small screwdriver and then set the gas pressure from its source. -
Page 8: Technical Notes & Best Practices
4 Maintenance 4.1 Cleaning the Device After Use The wetted parts of the BPR-1000 are all made with inert polymers, therefore minimal care is required. However, rinsing with a solvent/water stream after use is suggested. The rinse is especially recommended if liquids carrying salts are used. The liquids use to flush the device should be selected as not to react with the process fluids. -
Page 9: Periodic Maintenance
4.2 Opening the Device for Cleaning While we do not recommend opening the device, in some instances it may be required to eliminate solids. To open the device: 1. Open the valve on top of the device to depressurize it. 2. - Page 10 You may contact us by phone, +1 617-714-9806 or by email: Technical Questions Product Inquiries Orders support@zaiput.com sales@zaiput.com orders@zaiput.com Copyright © Zaiput Flow Technologies 101a 1 Avenue, Waltham, MA -02451 www.zaiput.com Last update: February 2021 P a g e...