Table of Contents
Advertisement
O Required Tools
12 VDC
TEST BULB
ELECTRICAL
SIDE-CUT
TAPE
PLIERS
Les
O Dashboard Specifications
THICKNESS
MIN. 3/16" (4.75 mm)
—||— MAX. 7/32" (5.56 mm)
=e 9-3/32" (53 mm)
7-5/32"
ee
ae
O Identify All Leads
The first step in installation is to identify all the
vehicle wires you'll use when hooking up your
sound system.
As you identify each wire, we suggest that you
label it using masking tape and a permanent
marker. This will help avoid confusion when mak-
ing connections later.
Note: Do not connect the power connector to the
stereo unit until you have made all connections.
If there are no plastic caps on the stereo hooking
wires, insulate all exposed leads with electrical
tape until you are ready to use them.
Identify the
leads in the following order.
Power Lead
A, If your vehicle has a radio or is pre-wired for one: `
§ ©
Battery Lead
Speakers
CQ-DP738/728EU
19
Advertisement
Table of Contents
