Use Energy Wisely; Service Information - Viking VCFW750 Installation Instructions Manual

To prevent personal injury, turn disposer off before attempting to clear jams.
3. If the disposer is still jammed, turn off disposer and water. Insert one end of self-service
wrenchette into center hole on bottom of disposer (see Figure C). Work wrenchette back
and forth until it turns one full revolution. Remove wrenchette.
4. Reach into disposer with tongs and remove object(s). Allow disposer motor to cool for 3 - 5
minutes and lightly push red reset button on the disposer bottom (see Figure C). (If motor
remains inoperative, check service panel for tripped circuit breakers or blown fuses.)
If the disposer is jammed too long (approximately 9 seconds), the thermal overload
protector will stop the motor (the motor will not hum). Wait 3 to 5 minutes, then
press the red reset button on the bottom of the disposer. If disposer has been
running for an extended period of time, you may have to wait 20 to 25 minutes for
the motor to cool before pressing the red reset button. Lightly push red reset button
on bottom of the disposer
Operation With the Dishwasher
If your dishwasher drains through your disposer, run the disposer for a short time before starting the dishwasher. This
will ensure that the disposer is free of any food waste. Such waste could cause a "backup" of the discharge water from
the dishwasher. DO NOT OPERATE THE DISPOSER WHILE THE DISHWASHER IS IN OPERATION. After operating the
dishwasher, run the disposer for a short time to clean and flush all particles discharged by the dishwasher into the
disposer down the main drain line.
When the dishwasher is in operation, we recommend the cover be placed in the DRAIN position. The will eliminate the
possibility of water splash out.

Use Energy Wisely

A food waste disposer uses a negligible amount of energy. Total energy requirements associated with operating a food
waste disposer will be minimized by following the recommendations in this manual.
If your disposer should fail to operate:
1. Is the grind wheel jammed? Make sure grind wheel is free to rotate.
2. Is the circuit breaker open, or is fuse blown?
3. Is the disposer wall switch turned "ON"?
If Service is Required:
1. Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or
distributor in your area.
2. Have the following information available:
-Model number
-Serial number
-Date purchased
-Name of dealer from whom you purchased the appliance.
3. Clearly describe the problem you are experiencing.
If you are unable to obtain the name of an authorized service agency, or continue to have service problems, call Viking, (888)
845-4641, or write to:
Record the information indicated below. You will need it if service is ever required. The serial and model numbers for your disposer
are located on an identification plate attached to the side at the bottom of the disposer.
Model Number
Date Purchased
Dealer's Name
Address
I I f f s s e e r r v v i i c c e e r r e e q q u u i i r r e e s s i i n n s s t t a a l l l l a a t t i i o o n n o o f f p p a a r r t t s s , , u u s s e e o o n n l l y y a a u u t t h h o o r r i i z z e e d d p p a a r r t t s s t t o o e e n n s s u u r r e e p p r r o o t t e e c c t t i i o o n n u u n n d d e e r r t t h h e e w w a a r r r r a a n n t t y y . .
CAUTION
Personal Injury

SERVICE INFORMATION

V V i i k k i i n n g g P P r r e e f f e e r r r r e e d d S S e e r r v v i i c c e e
1 1 1 1 1 1 F F r r o o n n t t S S t t r r e e e e t t
G G r r e e e e n n w w o o o o d d , , M M i i s s s s i i s s s s i i p p p p i i 3 3 8 8 9 9 3 3 0 0 U U S S A A
T T h h i i s s m m a a n n u u a a l l s s h h o o u u l l d d r r e e m m a a i i n n w w i i t t h h t t h h e e d d i i s s p p o o s s e e r r f f o o r r f f u u t t u u r r e e r r e e f f e e r r e e n n c c e e . .
Serial Number
Date Installed
7