Table of Contents
Advertisement
12.9 Removing and Remounting the Eject Lever
Springs
(1) Remove the holder assembly according to the
procedure in section 12.4.
(2) Remove the hook of the eject lever spring and
remove the eject lever spring.
(3) Remount the eject lever spring in the reverse
procedure of steps (1) and (2).
Fig. 12-9. Removing the Eject Lever Spring
12.10 Removing and Remounting the Eject Lever
(1) Remove the eject lever springs according to the
procedure in section 12.9.
(2) Remove the trigger lever assembly according to
the procedure in section 12.8.
(3) Remove the four stopper rings and washers
from the eject lever.
Each stopper ring has a slit, so it can be easily
removed by pinching the portion adjacent to
the slit by tweezers.
(4) Remove the eject lever.
(5) Remount the eject lever in the reverse
procedure of steps (1) to (4).
- 25 -
Fig. 12-10. Removing the Eject Lever
12.11 Removing and Remounting the Microswitch
Assembly
(1) Remove the holder assembly according to the
procedure in section 12.3.
(2) Remove the three soldered portions of the
microswitch assembly lead wires on the D
motor PC board.
(3) Remove the microswitch assembly set screw
and remove the microswitch assembly.
(4) Remount the microswitch assembly in the
reverse procedure of steps (1) to (3).
(5) Observe the instructions in the following table
when soldering the three lead wires onto the D
motor PC board.
No. on the D motor
Color of lead wire
PC board
1
Yellow
2
White
3
Blue
Advertisement
Table of Contents
