Techly I-TOOL-SD-182 Manual

EN
Dual Function
Iron Tip Cleaner
OXIDE REMOVAL
SOLDER REMOVAL
FEATURES
• With infrared sensor, the cleaner starts working automatically when the iron tip is
inserted in and stops when the tip is taken out.
• Safe and environment friendly with the separate inside structure and fully sealed
casing preventing tin waste from splashing around.
• Energy-saving with little power consumption.
• Works efficiently and cleans tips thoroughly.
• With dual cleaning function of solder removal and oxide removal.
• Can be used horizontally or at an angle.
ATTENTION
Please note the following safety notes to avoid malfunctions, damage or physical injury:
• In order to achieve the cleaner's best performance, always clean the iron tip when it is
hot.
• The cleaner is not a toy. Keep it out of children's reach.
• Never stick your fingers into the holes.
• Always unplug the cleaner when you clean it, change its brushes, during breaks or
finish your works.
• Never use adaptors other than the original one or an authorized one by the
manufacturer.
• If the cleaner fails, it must be repaired by a professional or a service agent of the
manufacturer to avoid hazard.
• Always get rid of the solder waste in the receptacle in time.
• This item is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the item by a person
responsible for their safety.
• Be warned of being burned: Do not touch the metal part when it's in use as its
temperature will be quite high.
OPERATION
• Connect the adaptor to the cleaner's outlet and plug it in.
• Put it at an angle or horizontally. Insert the iron tip into the hole of solder removal or
oxide removal and the cleaner will start working automatically within 2 seconds. Take
out the tip and the cleaner will stop working. Repeat several times if necessary until
the tip is completely clean.
• Unplug it after your work is done.
HOW TO SET ITS POSITION
AT AN ANGLE
WWW.TECHLY.COM
Thank you for purchasing this dual
function iron tip cleaner. To ensure the
best performance, please read the manual
thoroughly before using the cleaner.
Keep the manual handy for quick future
reference.
SPECIFICATIONS
• Adaptor input: AC 100-240V 50/60Hz
• Adaptor output: DC18V 0.5A
• DC outlet: 5.5*2.5mm
• Power: 2W
• Solder removal diameter: Ø7mm
• Oxide removal diameter: Ø10mm
• Net weight: 260g
• Dimensions: 133*83*69mm
Dual Function
Iron Tip Cleaner
OXIDE REMOVAL
SOLDER REMOVAL
HORIZONTALLY
HOW TO GET RID OF SOLDER WASTE
Pull out the receptacle and get rid of the solder waste.
HOW TO CHANGE THE BRUSHES
1. Pull out the receptacle and loosen the 4 screws on the bottom.
2. Open the casing and loosen the other 6 screws in the pictures below.
3. Open the cover, pull out the brushes and replace them with new ones.
4. Reassemble the rest parts.
In compliance with EU Directive WEEE this product is marked with this
symbol. It means that used electrical and electronic products should
not be mixed with general household waste. There is a separate
collections system for these products in compliance with WEEE
directive, otherwise contaminative and hazardous substances can
pollute the environment.
With the CE sign, Techly
basic European standards and directives.
AUTOMATIC SOLDER
IRON TIP CLEANER
ensures that the product is conformed to the
®