Risk Of Electric Shock; Connecting Optional Equipment; Specification - Crosley Conductor CR73 Instruction Manual

WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
RISK OF ELECTRIC
CAUTION: TO REDUCE
The lighting flash with
arrowhead symbol, within
THE RISK OF ELECTRIC
an equilateral triangle, is
SHOCK, DO NOT REMOVE
intended to alert user to
the presence of uninsulated
COVER (OR BACK). NO
"dangerous voltage" within
USER - SERVICEABLE
the product's enclosure
that may be of sufficient
PARTS INSIDE. REFER
magnitude to constitute
SERVICING TO QUALIFIED

risk of electric shock

to persons.
SERVICE PERSONNEL.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.

Specification

Frequency Range : AM 520 - 1710 KHz
: FM 87.5 - 108.5 MHz
Power Supply : AC 120V ~ 60Hz
Power Consumption : 18W
Speed : 33 /45 /78 RPM
Speaker : 3" X 5" 8ohm 5W x 2
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
SHOCK
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.

Connecting Optional Equipment

External Speakers
1
This radio is equipped with external speaker
outputs.
2
The speaker jacks for external speakers are
located on the back of the radio. Beside the
speaker jacks is a switch labeled (int./ext.) When
using external speakers, this switch must be
switched to the ext. position. Doing this turns off
the internal speakers in the radio and redirects
to power to the external speakers.
3
If you decide not to use the external speakers,
be sure the switch is on int. or the internal
speakers will not work.
External Speakers
1
You can connect your radio to different sources
using the auxiliary outputs.
2
Connect auxiliary cables to the LINE OUT
JACK (29) to the auxiliary inputs on the desired
component. See the owners manual for the
operating instructions on the desired component.
The LINE OUT JACK only puts out a signal.
Hooking up external speakers alone must be
hooked up using the External Speaker Jacks.
11