Advertisement
3. SPECIFICATION
MODEL NO.: .................................................EVBT1000
Capacity: ............................................................ 1000kg
Maximum Platform Height: ............................... 1750mm
Minimum Platform Height: .................................. 550mm
Platform Length: ............................................... 1500mm
Platform Width: .................................................. 800mm
4. ASSEMBLY
NOTE: The trolley comes fully assembled except for the handle
assembly and foot-pedal. Refer to Parts List.
4.1.
HANDLE
4.1.1.
Fit the handle to the frame using the supplied screws and washers.
4.2.
FOOT-PEDAL
4.2.1.
Insert the foot-pedal onto the drive shaft and fix in position using
the supplied fixings.
4.3.
JACK SUPPORTS
4.3.1.
These can be arranged to best support the battery being removed
these are best left until you know the arrangement required.
5. OPERATION
WARNING! Ensure you read, understand and follow the safety instructions. Ensure all Health and Safety, local authority, and general
‰
workshop practice regulations and recommendations are strictly
movement of heavy loads may be dangerous if not undertaken correctly.
WARNING! Be sure to insert the platform safety locks before raising on each side see fig.3 and removing to lower to its lowest
‰
point.
WARNING! Before each use, inspect the unit to ensure the warning markings are in place and are legible.
‰
5.1.
RAISING THE PLATFORM
NOTE: Ensure that any obstructions are removed.
5.1.1.
When in position for lifting the platform, ensure that the castor wheels are locked in position.
5.1.2.
Place jack supports and arrange to suit and tighten bolts supplied.
5.1.3.
Check that the jack pads are free from any damage.
5.1.4.
Pump the foot-pedal to raise the platform to the required height. The safety locks must be put into position to prevent the platform from
dropping.
5.2.
LOWERING THE PLATFORM
WARNING! Ensure the load will not foul on anything, and is clear of your hands and
‰
locks.
5.2.1.
Squeeze the lowering lever to lower the platform.
5.2.2.
Disconnect the safety locks by raising the table slightly and placing the safety bars back to the resting position.
5.2.3.
Squeeze the trigger to lower the platform to its lowest point.
5.2.4.
Unlock the castor wheels and
NOTE: With or without a load, always transport the lift with platform in its lowest position. When not in use, store the lift
with the platform in the lowest position.
Lifting
Foot Pedal
© Jack Sealey Limited
transport the load to the required destination.
Safety Locks
Lowering
resting position
Lever
fig.2
Original Language Version
Additional
positioning
Safety locks
adhered to when lifting or moving heavy loads. The lifting or
the handle when lowering to just before the safety
Safety Locks
fig.3
EVBT1000
Jack supports
Locks for table
Grease nipple
fig.1
Issue 3 (H,2,F)
08/06/23
Advertisement
